Abstract:We reported a low-temperature solution-processed method for the fabrication of AlOx thin films in the memory device. The detailed study is carried out to figure out the effect of varying annealing temperatures (150, 200, 250, 300, and 350 degrees C) on resistive switching characteristics of solution-processed aluminum oxide dielectric. The dielectric properties of AlOx films under different annealing temperatures were evaluated by atomic force microscopy (AFM), thermogravimetric analysis-differential scanning calorimetry (TGA-DSC), X-ray diffraction (XRD), attenuated total reflection Fourier transform infrared spectroscopy (ATR-FTIR) and X-ray photoelectron spectroscopy (XPS) firstly. Then the AlOx films were used as the switching dielectric layer for a variety of low-temperature solution-processed oxide resistive random access memory (RRAM) devices. It was found that forming voltage increased with increasing annealing temperature and forming free behavior could be achieved by 200 degrees C sample. No repeatable resistance switching characteristics were observed in the devices with minimum (150 degrees C) and maximum (350 degrees C) annealing temperatures. Compared with the ALD-derived AlOx based RRAM devices in previous study, enhanced performance like small forming voltage, large resistance ratio (<180) and narrow resistance and voltage distribution was achieved by the solution-processed AlOx based ones at the optimized low annealing temperatures of 200 to 250 degrees C, which would be applied in the bionic circuit simulated by synapses and neural networks. All three samples (200, 250, and 300 degrees C) obtained switching endurance up to 300 cycles and data retention over 10(4) s. Furthermore, the solution based fabrication method also has the potential in the flexible memory application due to the merit of the low-temperature process.

Reset-Voltage Controlled Resistance-State and Applications of Forming-Free Fe-Doped SrTiO3 Thin-Film Memristor

Ti/HfO2-Based RRAM with Superior Thermal Stability Based on Self-Limited TiOx

Forming-Free One-Selector/One-Resistor Characteristics of Oxygen-Rich ITO Based Transparent Resistive Switching Memory via Defect Engineering Using the Reactive Sputtering Process

High performance and low power consumption resistive random access memory with Ag/Fe<sub>2</sub>O<sub>3</sub>/Pt structure

A Forming-Free Bipolar Resistive Switching in HfOx-Based Memory with a Thin Ti Cap

Investigation of resistive switching properties in acceptor-induced Sr(Fe,Ti)O 3 thin film memristor

Anatomy of Resistive Switching Behavior in Titanium Oxide Based RRAM Device

Al2O3/HfO2 Functional Stack Films Based Resistive Switching Memories with Controlled SET and RESET Voltages

Tuning oxygen vacancies and resistive switching properties in ultra-thin HfO2 RRAM via TiN bottom electrode and interface engineering

Improvement of resistive switching characteristics in ZrO2 film by embedding a thin TiOx layer.

Effect of Stoichiometry on Resistive Switching Characteristics of STO Resistive Memory

Understanding the Switching Oxide Defect Formation and Recovery on HfOx Based RRAM Device

High performance, electroforming-free, thin film memristors using ionic Na 0.5 Bi 0.5 TiO 3

Current–voltage characteristics of sol–gel derived SrZrO3 thin films for resistive memory applications

Thermally Stable Transparent Resistive Random Access Memory Based on All‐Oxide Heterostructures

Insight into interface behavior and microscopic switching mechanism for flexible HfO2 RRAM

High‐Entropy Oxides‐Based Memristor: Outstanding Resistive Switching Performances And Mechanisms in Atomic Structural Evolution

Resistive switching and optical properties of strontium ferrate titanate thin film prepared via chemical solution deposition

Modulating Metallic Conductive Filaments Via Bilayer Oxides in Resistive Switching Memory

Enhanced Resistive Switching Performance of Aluminum Oxide Dielectric with a Low Temperature Solution-Processed Method

Stability Enhancement in Copper-Doped Iron Oxide Resistive Random Access Memory via RF Co-Sputtering