Abstract:Piezoresponse force-microscopy (PFM) has become the standard tool to investigate ferroelectrics on the micro- and nanoscale. However, reliability of PFM signals is often problematic and their quantification is challenging and thus not widely applied. Here, we present a study of the reproducibility of PFM signals and of the so-called PFM background signal which has been reported in literature. We find that PFM signals are generally reproducible to certain extents. The PFM signal difference between 180° domains on periodically-poled lithium niobate (PPLN) is taken as the reference signal in a large number of measurements, carried out in a low frequency regime (30-70 kHz). We show that in comparison to Pt coated tips, diamond coated tips exhibit improved signal stability, lower background signal and less imaging artifacts related to PFM which is reflected in the spread of measurements. This is attributed to the improved mechanical stability of the conductive layer. The average deviation of the mean PFM signal is 38.3%, for a diamond coated tip. Although this deviation is relatively high, it is far better than values from literature which showed a deviation of approx. 73.1%. Additionally, we find that the average deviation of the background signal from 0 is 11.6% of the PPLN domain contrast. Thus, the background signal needs to be taken into account when quantifying PFM signals and should be subtracted from PFM signals. Those results are important for quantification of PFM signals, since PPLN might be used for this purpose when PFM signals measured on PPLN are related to its macroscopic d33 coefficient. Finally, the crucial influence of sample polishing on PFM signals is shown and we recommend to use a multistep polishing route with a final step involving 200 nm sized colloidal silica particles.

Quantitative piezoelectric force microscopy: Influence of tip shape, size, and contact geometry on the nanoscale resolution of an antiparallel ferroelectric domain wall

Quantitative Lateral and Vertical Piezoresponse Force Microscopy on A Pbtio3 Single Crystal

Force-Electric Coupling of Nanoscale Ferroelectric Domains Based on Piezoelectric Force Microscopy (PFM)

Direct Measurement of Piezoelectric Response around Ferroelectric Domain Walls in Crystals with Engineered Domain Configuration

Nanoelectromechanics of Piezoresponse Force Microscopy

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

Accurate Vertical Nanoelectromechanical Measurements

Piezoelectrics: Influence of a Single Grain Boundary on Domain Wall Motion in Ferroelectrics (Adv. Funct. Mater. 10/2014)

Piezo-generated charge mapping revealed through Direct Piezoelectric Force Microscopy

Reply to “comment on ‘origin of Piezoelectric Response under a Biased Scanning Probe Microscopy Tip Across a 180° Ferroelectric Domain Wall’”

Effects of Domain Wall Proximity on Nanoscale Polarization Switching in Relaxor‐Ferroelectric Single Crystals

Choice of tip, signal stability and practical aspects of Piezoresponse-Force-Microscopy

Localized electromechanical interactions in ferroelectric P(VDF-TrFE) nanowires investigated by scanning probe microscopy

Nano-domain nucleation in front of moving domain wall during tip-induced polarization reversal in ion-sliced LiNbO3 thin films

Giant piezoelectricity of PNN-PIN-PT ceramics via domain engineering

Ferroelectric Domain Wall p-n Junctions

Controlled manipulation of conductive ferroelectric domain walls and nanoscale domains in BiFeO3 thin films

Atomic-environment-dependent thickness of ferroelastic domain walls

Piezoresponse Force Microscopy Studies on the Domain Structures and Local Switching Behavior of Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTiO3 Single Crystals