Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Withdrawal model for fiber motions in the tuft disentanglement

Investigation of the interactions between two contact fibers in the fiber suspensions

Numerical simulation on velocities of two interacting fibers in fiber suspension

Dynamic Tensile Behavior of Fiber Reinforced Materials Based on Fiber Layering Modeling

Research on the Interaction of Three Contact Fibers in the Fiber Suspensions

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Theoretical Research on Rotational Dispersion Coefficient of Fiber in Turbulent Shear Flow of Fiber Suspension

Coulomb frictional interfacial stresstransfer in fiber pull-out

The Motion of Fibers in an Evolving Mixing Layer

Discrete Element Method Models of Elastic and Elastoplastic Fiber Assemblies

Orientation Distribution and Rheological Properties of Fiber Suspensions Flowing Through Curved Expansion and Rotating Ducts

Modelling energy dissipation and hysteresis of woven fabrics with large deformation under single loading-unloading cycle

Numerical Simulation of the Mechanical Behavior of a Weft-Knitted Carbon Fiber Composite under Tensile Loading

Isometric fiber distribution in the roller drafting zone

Yarn/Yarn Friction Analysis Considering the Weaving Process of Textile Fabrics: Analytical Model and Experimental Validation

Behavior of Pull-Out and Movement Mechanisms of High-Performance Plain Weave Fabric Yarns

Computational modeling of the strength of staple yarn based on the random arrangement of fibers

Numerical investigation of fiber random distribution on the mechanical properties of yarn in-plain woven carbon fiber-reinforced composite based on a new perturbation algorithm:

Research on wearing behavior of fibers in a rotor by numerical simulation and experimental verification

Enhanced Modeling of Water Diffusion in Natural Fibers: Application to Diss Fibers

A Mesoscopic Constitutive Model for Woven Fabrics with Large Deformation