Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Numerical simulation on velocities of two interacting fibers in fiber suspension

Investigation of the interactions between two contact fibers in the fiber suspensions

Research on the Interaction of Three Contact Fibers in the Fiber Suspensions

NUMERICAL RESEARCH ON THE EFFECT OF FIBERS ON THE PROPERTY OF TURBULENT FIBER SUSPENSION IN A CHANNEL

Mathematical modeling of turbulent fiber suspension and successive iteration solution in the channel flow

Numerical simulation of two-dimensional squeeze-expansion flow of fiber suspensions

Numerical simulation of fiber orientation distribution in round turbulent jet of fiber suspension

Simulation of fiber suspension flowing through a stock pump impeller with two-way coupling

Rheological behavior of fiber suspensions in a turbulent channel flow.

Numerical Simulation of Interactions Between Rigid Rod-Like Polymers and Coherent Structures in a Mixing Layer

Numerical Prediction of Fiber Motion in A Branching Channel Flow of Fiber Suspensions

A New Formula for Predicting the Velocity Distribution in the Turbulent Fiber Suspensions of A Channel Flow

A Theoretical Model of Turbulent Fiber Suspension and Its Application to the Channel Flow

The Motion of Fibers in an Evolving Mixing Layer

RESEARCH ON THE SPECIFIC VISCOSITY OF SEMI-CONCENTRATED FIBER SUSPENSIONS

Stability in Channel Flow with Fiber Suspensions

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Characteristics of Fiber Suspension Flow in a Turbulent Boundary Layer

A New Expression for the Velocity Profile in the Turbulent Pipe Flows of Fiber Suspension

Numerical Prediction of the Flow Property in Round Turbulent Jet of Fiber Suspension

Research on the Motion of Particles in the Turbulent Pipe Flow of Fiber Suspensions