Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Investigation of the interactions between two contact fibers in the fiber suspensions

Research on the Interaction of Three Contact Fibers in the Fiber Suspensions

Numerical simulation on velocities of two interacting fibers in fiber suspension

Structure and Properties of Concentrated Fiber Suspensions in A Shear Flow

RESEARCH ON THE SPECIFIC VISCOSITY OF SEMI-CONCENTRATED FIBER SUSPENSIONS

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Stability in Channel Flow with Fiber Suspensions

Mathematical modeling of turbulent fiber suspension and successive iteration solution in the channel flow

NUMERICAL RESEARCH ON THE EFFECT OF FIBERS ON THE PROPERTY OF TURBULENT FIBER SUSPENSION IN A CHANNEL

Rheological behavior of fiber suspensions in a turbulent channel flow.

Multi-scale mathematic modeling of non-isothermal polymeric flow of fiber suspensions

The Stress-Microstructure Relationship in an Evolving Mixing Layer of Fiber Suspensions

Hydrodynamic Instability of Fiber Suspensions in Channel Flows

Rheology of concentrated suspension of fibers with load dependent friction coefficient

Orientation Distribution of Fibers and Rheological Property in Fiber Suspensions Flowing in a Turbulent Boundary Layer

Numerical simulation of two-dimensional squeeze-expansion flow of fiber suspensions

On the Structural Features of Fiber Suspensions in Converging Channel Flow

Fiber Orientation Distributions in Slit Channel Flows with Abrupt Expansion for Fiber Suspensions

Research on the Motion of Particles in the Turbulent Pipe Flow of Fiber Suspensions

The Motion of Fibers in an Evolving Mixing Layer

A New Formula for Predicting the Velocity Distribution in the Turbulent Fiber Suspensions of A Channel Flow