Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Discrete Element Method Models of Elastic and Elastoplastic Fiber Assemblies

Discrete Element Method Model of Elastic Fiber Uniaxial Compression

A FIBER BEAM ELEMENT FOR THE FINITE PARTICLE METHOD CONSIDERING SHEAR AND TORSION DEFORMATON

A Bonded Sphero-Cylinder Model for the Discrete Element Simulation of Elasto-Plastic Fibers

Mechanical Behaviors of Copolymer Elastomers: Experimental Characterization and Constitutive Modelling

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Effects of Fiber Shape on Mechanical Properties of Fiber Assemblies

Α Model of Computation of Elastic and Plastic Contact Considering Adhesion Effect

Cohesive zone modeling for viscoplastic behavior at finite deformations

New Discrete Element Models for Elastoplastic Problems

A Model for Computational Investigation of Elasto-Plastic Normal and Tangential Contact Considering Adhesion Effect

A Simplified Numerical Elastic-Plastic Contact Model for Rough Surfaces

Elasto-plastic and adhesive contact: an improved linear model and its application

Analytical Micromechanics Models for Elastoplastic Behavior of Long Fibrous Composites: A Critical Review and Comparative Study

A physics-based crystal plasticity model for the prediction of the dislocation densities in micropillar compression

Finite Element Analysis of Adhesive Contact Behaviors in Elastoplastic and Viscoelastic Media

A 3D objective material model for elastic-plastic damage behavior of fiber reinforced polymer composites

A mechanically-derived contact model for adhesive elastic-perfectly plastic particles. Part II: Contact under high compaction--adding a bulk elastic response

Development of the Concurrent Multiscale Discrete-Continuum Model and Its Application in Plasticity Size Effect

A mechanically-derived contact model for adhesive elastic-perfectly plastic particles. Part I: Utilizing the method of dimensionality reduction

3-D Elastic Analysis of Stress Transference Mechanism at the Interfaces in Fiber Reinforced Concrete