Abstract:In this study, a dynamic constitutive model for woven-carbon-fiber-reinforced plastics (CFRP) is formulated by combining dynamic tensile test data and fitting curves and incorporating variation rules established for the modulus of elasticity, strength, and fracture strain with respect to the strain rate. The dynamic constitutive model is then implemented with finite element software. The accuracy and applicability of the dynamic constitutive model are evaluated by comparing the numerically predicted load–displacement curves and strain distributions with the test data. The stress distribution, failure factor, modulus, and strength of the material under dynamic tension are also explored. The results show that the response simulated with the dynamic constitutive model is in good agreement with the experimental results. The strain is uniformly distributed during the elastic phase compared with the DIC strain field. Subsequently, it becomes nonuniform when stress exceeds 600 MPa. Then, the brittle fracture occurs. With the increase in the strain rate, the input modulus decreased, and the tensile strength increased. When the displacement was 0.13 mm, the simulation model was damaged at a low strain rate, and the stress value was 837.8 MPa. When it reached the high strain rate of 800 s−1, no failure occurred, and the maximum stress value was 432.5 MPa. For the same specimen, the strain rate was the smallest on both clamped ends, and the modulus and strength were large at the ends and small in the middle. The fitting curve derived from the test data was completely input into the dynamic constitutive model to better capture the dynamic change in the material properties.

Dynamic Tensile Behavior of Fiber Reinforced Materials Based on Fiber Layering Modeling

Micro Failure Analysis of Fiber Metal Laminates

Keynote: EXPLICIT MODELLING OF FIBRE PULLOUT IN CEMENTITIOUS COMPOSITES

A Pull-out Equivalent Telescopic Layered Failure Model of Carbon Fiber Bundles in Seawater Sea-Sand Cementitious Matrix

Out-of-plane Tensile Failure Behavior of Fiber Reinforced Composites Due to Lay-Up Temperature Induced Intra-Ply and Inter-Ply Voids

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Coulomb frictional interfacial stresstransfer in fiber pull-out

On the Static and Dynamic Properties of Fiber-Reinforced Polymer Composites: A Three-Phase Constitutive Model

Properties of Frictional Bridging in Fiber Pull-out for Fiber-Reinforced Composites

AN INTERFACIAL PULLOUT MODEL FOR HOOKED FIBER IN CEMENTITIOUS MATERIALS

A cohesive zone model for the elevated temperature interfacial debonding and frictional sliding behavior

A Unified Model for Fibers With Divergent Pullout Behaviors in Strain Hardening Cementitious Composites (SHCC)

Progressive damage modelling and experimental investigation of three-dimensional orthogonal woven composites with tilted binder

Fatigue failure mechanism analysis and life prediction of short fiber reinforced polymer composites under tension-tension loading

Micromechanical modeling for longitudinal tensile property of unidirectional CFRP considering dispersion of fiber properties

A progressive damage model for carbon fiber-reinforced polymer laminates subjected to fastener pull-through failure

Development of the Nonlinear Bond Stress–Slip Model of Fiber Reinforced Plastics Sheet–Concrete Interfaces with a Simple Method

Evaluation of Carbon Fiber/epoxy Interfacial Strength in Transverse Fiber Bundle Composite: Experiment and Multiscale Failure Modeling

Modeling the pullout behavior of short fiber in reinforced soil

A Discrete-Continuum Coupled Finite Element Model to Simulate All Failure Modes in Fibre Reinforced Concrete

A Dynamic Constitutive Model and Simulation of Braided CFRP under High-Speed Tensile Loading