Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

Metallurgical re-examination of wear modes II: adhesive and abrasive

Friction coefficient and wear mode transition in micro-scale abrasion tests

Asperity level characterization of abrasive wear using atomic force microscopy

Development, mechanical characterization and analysis of dry sliding wear behavior of AA6082–Metakaolin metal matrix composites

Some metallurgical factors controlling the adhesive and abrasive wear resistance of steels. A review

Abrasive and adhesive wear behaviour of metallic bonds in a synthetic slurry test for wear prediction in reinforced concrete

Wear mechanism, subsurface structure and nanomechanical properties of additive manufactured Inconel nickel (IN718) alloy

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

Mechanisms of abrasive wear in lubricated contacts

Tribological mechanisms of slurry abrasive wear

An examination of a mild wear process

Analysis of the abrasive wear mechanism by successive observations of wear processes in a scanning electron microscope

Experimental Study of Abrasive, Mechanical and Corrosion Effects in Ring-on-Ring Sliding Contact

Abrasive wear mechanisms and their relation to rock properties

Adhesive wear performance of hardmetals and cermets

Finite element analysis of sliding wear on the borided AISI 316L stainless steel

Wear behavior and damage characterization for AISI 52100 bearing steels: Effect of hardness and spherical carbides

Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials

Mechanisms of abrasive wear in a boronized alloy steel

Adhesive transfer to abrasive particles in abrasion testing

Waviness Affects Friction and Abrasive Wear