Mechanisms of abrasive wear in a boronized alloy steel

A.G. Wang,I.M. Hutchings

DOI: https://doi.org/10.1016/0043-1648(88)90241-4

IF: 4.695

1988-06-01

Wear

Abstract:The effects of abrasive hardness and size on the two-body abrasive wear mechanisms of a boronized low alloy steel are described in this paper. It is found that the wear resistance of the boronized steel is much greater against alumina abrasive than against silicon carbide. This difference in wear resistance is much enhanced when the particle size or the applied load is increased. Scanning electron microscopy of the worn specimens and of the used abrasive papers revealed that the enhanced difference in wear resistance between coarse alumina and silicon carbide papers is due to a change in the wear mechanism produced by silicon carbide papers with increasing abrasive particle size. A critical abrasive particle diameter is found for wear by silicon carbide papers, above which the wear rate increases much more rapidly owing to large scale brittle fracture of the boride surface layer; no such transition was found in wear by alumina papers. Different mechanisms of abrasive deterioration operated for wear of unboronized steel and of boronized steel.

engineering, mechanical,materials science, multidisciplinary