Abstract:Traditionally, metal matrix composites reinforced with uniformly dispersed carbon nanotube (CNT) have shown significant enhancement in strength, but always accompanied by the deterioration of uniform elongation (UE). In this study, we proposed a novel strategy to achieve the prominent strength‐ductility combination of carbon CNT reinforced Cu composites. The strategy made use of the architecture design via mixing the CNT/Cu composite powders (prepared by the molecular‐level mixing method) with coarse‐grained Cu powders. The bulk composites with a controlled inhomogeneous microstructure were designed and fabricated, in which the reinforcing phase is inhomogeneously distributed at the micro‐scale but homogeneous at the macro‐scale. The effects of fine and coarse grain proportions on the microstructure evolution and plastic deformation capacity of bimodal‐grained Cu composites were investigated. When the mixed ratio of refined CNT/Cu powder to coarse‐grained Cu was 1:1, the ultimate tensile strength (UTS) and UE of bimodal‐grained Cu composites were 384 MPa and 26.9%, respectively. Such good strength‐plasticity compatibility was attributed to the combined effects of hetero‐deformation‐induced (HDI) stress and CNT strengthening mechanisms. This study provided insights for evading the strength‐ductility trade‐off in high‐performance metal matrix composite by architecture design. This article is protected by copyright. All rights reserved.

Enhanced strain hardening by bimodal grain structure in carbon nanotube reinforced Al–Mg composites

CNT-induced heterogeneous matrix grain structure in CNTs/Al composites

Towards Homogeneous Distribution of Coarse Grain in a Tri-Modal Al-based Composites Utilizing Localized Grain Growth

Trimodal Grain Structure Enables High-Strength CNT/Al-Cu-Mg Composites Higher Ductility by Powder Assembly & Alloying

The enhanced mechanical properties and strain-hardening capability of CNT/Al composites achieved by heterogeneous micro-laminated architecture

Study on the Mechanism of CNTs Regulating the Microstructures and Properties of Al–Cu–Mg Alloy

Strain Rate Sensitivity and Deformation Mechanism of Carbon Nanotubes Reinforced Aluminum Composites

Optimizing Heterostructure Parameters Towards Enhanced Toughening in Micro/nano-Reinforced Bimodal-Grained Al Alloy Composites

Grain Refinement and Superplastic Behavior of Carbon Nanotube Reinforced Aluminum Alloy Composite Processed by Cold Rolling

Enhanced Combination of Strength and Ductility in Ultrafine-Grained Aluminum Composites Reinforced with High Content Intragranular Nanoparticles

Strengthening and Deformation Mechanisms in Nanolaminated Single-Walled Carbon Nanotube-Aluminum Composites

Powder Assembly & Alloying to CNT/Al–Cu–Mg Composites with Trimodal Grain Structure and Strength-Ductility Synergy

Strengthening and toughening mechanisms of CNTs/Mg–Al composites prepared via powder metallurgy combined with hot extrusion

Enhanced Mechanical Properties of CNT/Al Composite Through Tailoring Grain Interior/grain Boundary Affected Zones

Enhanced ductility by Mg addition in the CNT/Al-Cu composites via flake powder metallurgy

High-strength CNT/Al-Zn-Mg-Cu Composites with Improved Ductility Achieved by Flake Powder Metallurgy Via Elemental Alloying

Towards strong and stiff carbon nanotube-reinforced high-strength aluminum alloy composites through a microlaminated architecture design

Back stress in strain hardening of carbon nanotube/aluminum composites

Achieving good strength‐plasticity compatibility in Cu composites via carbon nanotube (CNT)‐induced heterogeneous bimodal structure

Structural modeling and mechanical research of carbon nanotube reinforced aluminum matrix composites using strain gradient theory

Evolution of Microstructure and Mechanical Properties of CNTs/Al-Mg Composites Prepared by Powder Metallurgy