Abstract:Cu/Al composites have the excellent properties of both Cu and Al, and have the properties of light weight and high conductivity, so they have been widely concerned. In this paper, 5-mm-thick Cu/Al composites prepared by the cast-rolling process are used as experimental materials. To reveal the strengthening and toughening mechanisms of the Cu/Al composites, the interfacial structure, micro-morphology, stress-strain condition, and GND distribution of Cu/Al composites before and after deformation were characterized utilizing TEM, TKD, and EBSD. The results show that the submicron intermetallic compounds Al 2 Cu and Al 4 Cu 9 are formed from the casting-rolling Cu/Al composites. After 15% tensile deformation, many gaps occurred in the interface layer, but at the gaps, there was no crack spreading to the Cu and Al layers. Meanwhile, the deformation in different directions occurs in the Cu grains near the interface, forming a dislocation wall, and the entanglement of the dislocation occurs in the Cu layer near the interface, which contributes to the improvement of tensile strength. The Al layer near the interface layer produces kink bands, which helps to improve the ductility of the composites. Besides, due to the action of the hard intermetallic compound layer, with the increase in tensile deformation, a large number of GND are gradually accumulated in the Cu and Al layers near the interface, resulting in remote back stress, which makes the softer Cu and Al layers obtain higher strength. At the same time, the back stress caused by GND will induce strain hardening, which helps to maintain ductility, so that Cu/Al composites have higher plastic deformation ability while improving mechanical properties.

Effects of the addition of CNTs and Al alloying on the microstructure and properties of Cu-(Al)/CNTs composites

Preparation, microstructure and properties of Cu-8.3Al/CNTs composites with different volume fractions of CNTs

Study on the Mechanism of CNTs Regulating the Microstructures and Properties of Al–Cu–Mg Alloy

Improvement of interfacial interaction and mechanical properties in aluminum matrix composites reinforced with Cu-coated carbon nanotubes

Evolution of Microstructure and Mechanical Properties of CNTs/Al-Mg Composites Prepared by Powder Metallurgy

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy

Remarkable improvement of mechanical properties of layered CNTs/Al composites with Cu decorated on CNTs

Effect of Carbon Nanotubes as Reinforcement on the Mechanical Properties of Aluminum-Copper-Magnesium Alloy

Microstructure and Mechanical Properties of Cu-CoatedCarbon-Nanotubes-Reinforced Aluminum Matrix Composites Fabricated by Ultrasonic-Assisted Casting

Enhanced ductility by Mg addition in the CNT/Al-Cu composites via flake powder metallurgy

Study on strengthening and toughening mechanisms of cu/Al composites dominated by interface layer

Investigation on the Microstructure and Mechanical Properties of CNTs-AlSi10Mg Composites Fabricated by Selective Laser Melting

Effects of the addition of Ni-plated carbon nanotube on the microstructure and properties of injection molded FeAl

Architectural and component design of CNTs/Al hierarchical composite for enhanced mechanical/thermal properties

Effect of Cu addition on the microstructure, thermal physical properties and cyclic ablation of C/C-AlSi composite

Study on Microstructure and Mechanical Properties Modification of Cu-Ti3AlC2 Composites by Ni Element

Effect of powder microstructure on the thermal and mechanical properties of hot extruded Al-CNT composite

Microstructures, thermal and mechanical properties of Al–Si-CNT composites for thermal management applications

Improving the mechanical properties of carbon nanotubes reinforced pure aluminum matrix composites by achieving non-equilibrium interface

Influence of adding Cu element on properties of Al/Al2O3 composite materials

Effect of CNTs on microstructure, mechanical and wear properties of the AZ91–3B 4 C–3SiC– x CNTs composites