Abstract:Controlling the interfacial interaction is a prerequisite for the preparation of aluminum matrix composites reinforced by carbon nanotubes (CNTs) with high performance. In this paper, Cu-coated CNTs fabricated by the compound reduction method were applied to control the interfacial interaction between carbon nanotubes and aluminum matrix for improving the interfacial bonding and mechanical properties of aluminum matrix composites. The microstructure, interfacial structure, interfacial interaction, and mechanical properties of Cu-coated composite were studied in detail. The in-depth study results show that Cu nanoparticles act as a bridge connecting the carbon nanotubes and matrix and forming Al2Cu intermetallic, which is in favour for better dispersion of carbon nanotubes and interfacial bonding. In addition, Cu nanoparticles are preferentially deposited at the defects of carbon nanotubes to repair the defects and inhibit the formation of brittle Al4C3 phases. As a result, Cu-coated composite displays the superior strength with yield strength and ultimate tensile strength of 203 MPa and 287 MPa, which are 45% and 38% higher than those of matrix (140 MPa and 207 MPa) and 8% and 12% higher than those of uncoated composite (188 MPa and 256 MPa), respectively. The introduction of Cu nanoparticles can significantly improve the interfacial bonding strength of Cu-coated composite, ensuring the effective transfer of load from the matrix to carbon nanotubes and exerting its strengthening and toughening effect.

Enhanced ductility by Mg addition in the CNT/Al-Cu composites via flake powder metallurgy

Strengthening and toughening mechanisms of CNTs/Mg–Al composites prepared via powder metallurgy combined with hot extrusion

Study on the Mechanism of CNTs Regulating the Microstructures and Properties of Al–Cu–Mg Alloy

Enhanced load transfer by designing mechanical interfacial bonding in carbon nanotube reinforced aluminum composites

Remarkable improvement of mechanical properties of layered CNTs/Al composites with Cu decorated on CNTs

Evolution of Microstructure and Mechanical Properties of CNTs/Al-Mg Composites Prepared by Powder Metallurgy

Balanced strength and ductility in CNT/Al composites achieved by flake powder metallurgy via shift-speed ball milling

Effects of the addition of CNTs and Al alloying on the microstructure and properties of Cu-(Al)/CNTs composites

Toughening and strengthening of Cu-coated carbon nanotubes reinforced AZ61 magnesium matrix nanocomposites by improving interfacial bonding

Enhanced strain hardening by bimodal grain structure in carbon nanotube reinforced Al–Mg composites

CNT-induced heterogeneous matrix grain structure in CNTs/Al composites

High mechanical strengthened CNTs/Al composite concepts with robust interface and intragranular reinforcement achieved via interfacial thermite reaction

Improvement of interfacial interaction and mechanical properties in aluminum matrix composites reinforced with Cu-coated carbon nanotubes

Enhancement of thermal–mechanical performances via a selective CNTs configuration in laminated CNTs/AZ31B composite

Architectural and component design of CNTs/Al hierarchical composite for enhanced mechanical/thermal properties

Acquiring Mg-Ag microalloying TiB 2 /Al-4.5Cu composite simultaneously with ultrahigh strength and ductility via optimized salt-metal reaction and multistage heat treatment

Developing Fittingly Comprehensive Performance Carbon Nanotube/Mg-6Zn Sheets with Substantial Enhancement in Formability

Strengthening Ni-Coated CNT/Mg Composites by Optimizing the CNT Content

Enhancement of load transfer by interfacial bonding in Al-Cu-Mg joints under the in-situ synergistic effect of carbon nanotubes and silicon nitride

The enhanced mechanical properties and strain-hardening capability of CNT/Al composites achieved by heterogeneous micro-laminated architecture

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy