Abstract:Controlling the interfacial interaction is a prerequisite for the preparation of aluminum matrix composites reinforced by carbon nanotubes (CNTs) with high performance. In this paper, Cu-coated CNTs fabricated by the compound reduction method were applied to control the interfacial interaction between carbon nanotubes and aluminum matrix for improving the interfacial bonding and mechanical properties of aluminum matrix composites. The microstructure, interfacial structure, interfacial interaction, and mechanical properties of Cu-coated composite were studied in detail. The in-depth study results show that Cu nanoparticles act as a bridge connecting the carbon nanotubes and matrix and forming Al2Cu intermetallic, which is in favour for better dispersion of carbon nanotubes and interfacial bonding. In addition, Cu nanoparticles are preferentially deposited at the defects of carbon nanotubes to repair the defects and inhibit the formation of brittle Al4C3 phases. As a result, Cu-coated composite displays the superior strength with yield strength and ultimate tensile strength of 203 MPa and 287 MPa, which are 45% and 38% higher than those of matrix (140 MPa and 207 MPa) and 8% and 12% higher than those of uncoated composite (188 MPa and 256 MPa), respectively. The introduction of Cu nanoparticles can significantly improve the interfacial bonding strength of Cu-coated composite, ensuring the effective transfer of load from the matrix to carbon nanotubes and exerting its strengthening and toughening effect.

Achieving good strength‐plasticity compatibility in Cu composites via carbon nanotube (CNT)‐induced heterogeneous bimodal structure

Microstructure‐Property Relations in the Tensile Behavior of Bimodal Nanostructured Metals

Tuning the Strength-Ductility Synergy of Nanograined Cu Through Nanotwin Volume Fraction

Improving the strength-ductility synergy of carbon nanotubes reinforced Cu matrix composites through interfacial regulation

Attaining the strength-plasticity-electricity balance of carbon nanotube/Cu composites through combining the intragranular carbonized polymer dots distribution

Enhancement of mechanical properties and conductivity in carbon nanotubes (CNTs)/Cu matrix composite by surface and intratube decoration of CNTs

The synergistic effects of heterogeneous structures enhance the strength-ductility of Al-Cu composites

Optimization of the mechanical properties of CNTs/Cu composite by regulating the size of interfacial TiC

CNT-induced heterogeneous matrix grain structure in CNTs/Al composites

Achieving high ductility in layered carbon nanotube/copper composite prepared by composite electrodeposition

Strength-ductility synergy in a novel carbon nanotube-high entropy alloy co-reinforced aluminum matrix composite

The enhanced mechanical properties and strain-hardening capability of CNT/Al composites achieved by heterogeneous micro-laminated architecture

Improvement of interfacial interaction and mechanical properties in aluminum matrix composites reinforced with Cu-coated carbon nanotubes

Microstructure and Mechanical Properties of Cu-CoatedCarbon-Nanotubes-Reinforced Aluminum Matrix Composites Fabricated by Ultrasonic-Assisted Casting

Introducing β-Ti ductile-zones for enhancing both strength and ductility in heterostructured titanium alloy composites

Enhanced strain hardening by bimodal grain structure in carbon nanotube reinforced Al–Mg composites

Regulating the mechanical properties and electrical conductivity of CNTs/Cu composites by tailoring nano-sized TiC on the surface of intact CNTs

Enhancement mechanisms of mechanical, electrical and thermal properties of carbon nanotube-copper composites: A review

Mechanical and Conductive Properties of Cu Matrix Composites Reinforced by Oriented Carbon Nanotubes with Different Coatings

Simultaneous achievement of high strength and high ductility in copper matrix composites with carbon nanotubes/Cu composite foams as reinforcing skeletons

Simultaneously enhanced strength and ductility of copper composites by tailoring the intragranular carbonized polymer dots distribution