Sustaining an excellent strength-ductility combination of a PM α + β titanium alloy with fine prior β grains and heterogeneous microstructure

Bowen Zhang,Zhujun Liu,Xiaogang Wu,Deliang Zhang

DOI: https://doi.org/10.1016/j.jallcom.2022.166736

IF: 6.2

2022-12-10

Journal of Alloys and Compounds

Abstract:Two samples of an α + β Ti-4Al-4Mo-4Sn-0.5Si (wt%) alloy, one with fine prior β grains and a heterogeneous microstructure and the other with coarse prior β grains and a homogeneous microstructure were prepared by extrusion of compacts of TiH2/Al/Mo/Sn/Si powder blend at 1200 and 1300 °C respectively. The heterogeneous microstructure is manifested by softer Mo-rich regions with a full α/β lamellar structure containing a high number density of parallel and nanometer sized FCC δ (TiH) needles in a harder matrix with a microstructure consisting of interweaved α plates and β transformed structure (βt) domains and grain boundary α (GB α) layers. The matrix also contains a small fraction of Sn-rich regions which have the same microstructure as the matrix. The Mo-rich and Sn-rich regions form due to the limited diffusion of Mo and Sn alloying elements. This heterogeneous microstructure sustains a high tensile yield strength of 1199 MPa, a high strain hardening rate, and an excellent tensile ductility of 12.0%. In contrast, the homogeneous microstructure comprising of interweaved α plates and βt domains together with GB α layers sustains a similar high strength, but a clearly lower strain hardening rate and a significantly lower tensile ductility of 3.5%. Non-homogeneous deformation capacity, the release of energy by forming numerous microcracks and the intermittent growth of microcracks of the heterogeneous microstructure suggest that this microstructure has a high plasticity and high resistance to the growth of microcracks.

materials science, multidisciplinary,chemistry, physical,metallurgy & metallurgical engineering