Abstract:Organic photovoltaic solar cells can offer advantages of being mechanically flexible and durable, large area devices, lightweight, made from a diversity of materials and low-cost fabrication. Their efficiency is, however, still too low for commercial exploitation. Empirical observations reveal that polymer–fullerene (P3HT:PCBM) based solar cell performance depends on thermal annealing processes employed, especially the annealing temperatures and durations. The annealing parameters are known to influence the energetics and kinetics of the blending process or morphology, but the associated physics is not fully understood. In this work, current density–voltage characteristics of P3HT:PCBM bulk heterojunction organic solar cells, thermally annealed at different temperatures, 65–160 °C post fabrication, were investigated under dark and illuminated conditions, and compared to their as-cast counterparts. In certain electrical regimes, as-cast devices showed higher values of current density in comparison to the corresponding annealed devices. Such performance was attributed to air-borne chemical doping of the as-cast semiconductor layer, which creates electrically conductive percolation pathways within the as-cast devices. We propose that annealing of semiconductors must be a two-step process, which first initiates decrease in conductivity, followed by its increase. As-cast devices P3HT–PCBM bulk heterojunction solar cells prepared under atmospheric conditions were observed to have comparatively superior photovoltaic performance in comparison to thermally annealed devices. The efficiency drop in the annealed counterparts is attributed to dedoping due to thermal annealing. An annealing temperature of ~ 140 °C was found to be optimum for power conversion efficiency in the bulk heterojunction, 1:1 by mass, P3HT:PCBM based solar cells.

The effect of the curing process on illuminated annealing of silicon heterojunction solar cells

Dark and illuminated J(V) characteristics of thin layered bulk heterojunction P3HT:PCBM sandwich solar cells after thermal treatment

Effect of the hydrogen annealing on the properties of Mo/CuIn1-xGaxSe2/CdS solar cells junction

Post-Fabrication Annealing Effects in Polymer-Nanotube Photovoltaic Cells

Insights into the Heat‐Assisted Intensive Light‐Soaking Effect on Silicon Heterojunction Solar Cells

Resistivity analysis on the enhancement of silicon heterojunction solar cells in light-thermal treatment

Investigation of Annealing Effects on Microstructure of Hybrid Nanocrystal–polymer Solar Cells by Impedance Spectroscopy

Transferability of the light-soaking benefits on silicon heterojunction cells to modules

Prolonged Annealing Improves Hole Transport of Silicon Heterojunction Solar Cells

Fast screen printing and curing process for silicon heterojunction solar cells

The effect of thermal annealing on defect states, light intensity and photocurrent of organic solar cells

Effect of Vacuum Rapid Annealing Treatment on Performance of CIGS Solar Cells

Effect of annealing on microstructure and photoluminescence of nano-composite silicon film

Reassessment of silicon heterojunction cell performance under operating conditions

A study on the improvement of amorphous silicon/crystalline silicon heterojunction solar cells by microwave processing

Improved Electrical Performance of Low-Temperature-Cured Silver Electrode for Silicon Heterojunction Solar Cells

The Effect of Annealing Treatment on Performance of Interdiffused Organic Photovoltaic Devices

Post annealing to improve the sheet resistance and uniformity of emitter for enhancing conversion efficiency of mass-produced mc-Si solar cells

Carrier Injection and Annealing‐Enhanced Electrical Performance in Tunnel Oxide‐Passivated Contact Silicon Solar Cells

Investigation of the effect of forming gas annealing on front silver electrodes of c-Si solar cells