Abstract:Goal. During the production of railway axles, the main target is to obtain a uniform metal structure with a grain size not larger than number 5 across the entire section of the produced axle. Moreover, in accordance with the demands of railway axle consumers, the differences in grain size numbers should not exceed 2. However, due to multi-stage processing and repeated heating of axle material, the fulfillment of aforesaid requirements is very difficult and the differences in grain size numbers are usually found as 4. Therefore, it is necessary to develop a special deformation regime for controlling the sizes and the uniformities of metal grains in the finished product. Methods. We employed experimental and theoretical investigations to reveal the microstructure refinement in the deformation zone of the produced railway axle. The experimental investigation was carried out under the production conditions, whereas the theoretical investigation was performed based on the theory of plasticity and finite element method. Results. Furthermore, the regularities of process parameters in the deformation zone were revealed; hence, a new deformation regime was developed, and consequently, the quality of the finished railway axle was improved. Scientific novelty. Rolling of solid railway axle required special de-formation regimes that differed from the deformation regimes for rolling of other types of products. Deformations in vertical and edging directions with edging reduction were less penetrative to the central zone of the billet as compared to surface layers, thus resulting in an increase in energy consumption and equipment load of the rolling mill. Rolling with edging reduction caused a worse de-formation at the central zone of the billet in the box caliber.Rolling without edging reduction caused large deformations in central layers of the billet and led to a significant improvement in the metal structure of the axle.

Effect of Rotary Swaging on Mechanical Behaviors of Axle Steel Rod

Effect of Rotary Swaging and Annealing on Mechanical Properties and Microstructure Evolution of Aeroengine High-Temperature Alloy Steel Tube

Effect of rotary swaging on the microstructure and mechanical properties of high-strength Mg-Mn-Al-Ca-Zn alloys

Effect of Rotary Swaging on the Structure, Mechanical Characteristics and Aging Behavior of Cu-0.5%Cr-0.08%Zr Alloy

Microstructure of the Advanced Titanium Alloy VT8M-1 Subjected to Rotary Swaging

Microstructure evolution and mechanical properties of commercial pure titanium subjected to rotary swaging

Processing and microstructure analysis on the precision rotary swaging of inner-stepped aero-engine shaft

Effect of Fibrous Macrostructure on Mechanical Properties, Anisotropy and Fracture Mechanism of Roller Bearing Ring

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Rotary Swaging Forming Process of Tube Workpieces

Improvement of Axial Forging Process for Spline Shaft by Die Design

The development of a new deformation regime for microstructure refinement in solid railway axles by hot deformation optimization

Deformation Mechanism and Performance Improvement of Spline Shaft with 42crmo Steel by Axial-Infeed Incremental Rolling Process

Effect of annealing temperature on texture and residual stress of Ti-6Al-4V alloy seamless tubing processed by cold rotary swaging

Study on Warm Forming Effects of the Axial-Pushed Incremental Rolling Process of Spline Shaft with 42crmo Steel

Energy-controlled rotary swaging process for tube workpiece

Failure Analysis of Cold Rotary Swaging Die

Study of Microstructure and Mechanical Properties by Torsional Behavior in Axial Closed Die Rolling Forming

Numerical Modeling and Anvil Design of High-Speed Forging Process for Railway Axles

Deformation Characteristic and Microstructure Evolution of Gh4169 Alloy Induced by Axial Upsetting and Axial Rotary Forging

Influence of Process Fluctuations on Residual Stress Evolution in Rotary Swaging of Steel Tubes