Abstract:This study deals with thorough investigation of stress-strain parameters within an innovatively processed tungsten heavy alloy (THA). THAs are challenging materials featuring exceptional mechanical and physical properties and they are applicable in various demanding industrial fields, such as in the aeronautics, medicine, or military. The herein studied material is a WNiCo alloy prepared from original powders via powder metallurgy. The pre-sintered material was processed via plastic deformation, in particular hot rotary swaging with the usage of induction heating directly before a swaging pass. The experimental study was supplemented with numerical simulation of the deformation process, which was performed via the finite element method (FEM). The simulation was primarily focused on prediction of the development of effective imposed strain during the swaging process performed in multiple steps, and its correlation with stress distribution during swaging. The numerically predicted effective imposed strain development was subsequently verified via Vickers microhardness measurements, whereas the predicted results of stress distribution were validated via experimental observation of residual stress distribution performed via analysing scans acquired by scanning electron microscopy (SEM, electron backscatter diffraction analysis). The results showed that the deformation technology consisting of induction heating and hot rotary swaging was well optimized as the swaged billets featured satisfactory surface roughness and no surface cracks. Also, the tungsten agglomerates within the structure exhibited deformation in the direction of the main acting swaging force, especially in the locations the effective imposed strain in which was the highest. The values of predicted effective imposed strain and microhardness correlated reliably with the experimentally acquired and predicted results of residual stress distribution. In other words, the locations the effective strain in which was the highest also exhibited a more significant presence of residual stress.

Processing and microstructure analysis on the precision rotary swaging of inner-stepped aero-engine shaft

Design and analysis of the mandrel structure for a composite S-shaped inlet

Failure Analysis of Cold Rotary Swaging Die

Effect of Rotary Swaging and Annealing on Mechanical Properties and Microstructure Evolution of Aeroengine High-Temperature Alloy Steel Tube

Numerical simulation and experiment study on hot extrusion process of 18Ni (250) maraging steel large fan shaft for aero-engines

Rotary Swaging Forming Process of Tube Workpieces

Isothermal precision forging of complex-shape rotating disk of aluminum alloy based on processing map and digitized technology

Effect of Rotary Swaging on Mechanical Behaviors of Axle Steel Rod

Effect of forging sequence and heat treatment on microstructure of high-duty power-plant shaft made of Cr-Mo ultra-high strength steel

Deformation Characteristic and Microstructure Evolution of Gh4169 Alloy Induced by Axial Upsetting and Axial Rotary Forging

Improvement of Axial Forging Process for Spline Shaft by Die Design

Based on SolidWorks Processing Method and Finite Element Analysis of Slender Shaft

Investigation on the inner hole spiral-groove of cross wedge rolling of hollow shafts with mandrel

Study of Manufacturing Process of Holes in Aeroengine Heat Shield

Energy-controlled rotary swaging process for tube workpiece

Stress-Strain Distribution Within Rotary Swaged Tungsten Heavy Alloy

Isothermal precision forging process of aluminum alloy cylindrical housing

Experimental Study on Process of Precision Forging of an Aluminium-Alloy Rotor

STUDY ON THE NUMERICAL SIMULATION OF MULTI-STAGE ROTARY FORGING OF A NON-AXISYMMETRIC PART AND THE CAE ANALYSIS OF THE DIE STRENGTH

Analysis on the Process of Cold Enclosed Precision Forging of Starlike Sleeve

Numerical Simulation Research on Final Forging Process of 700MW Class Heavy Hydro-generator Shaft