Abstract:The problem of ammonium bisulfate (ABS) deposition blocking and corroding air preheaters and economizers in boilers became severe, as the selective catalyst reduction (SCR) system was widely used in the coal-fired boilers to meet the stringent nitrogen oxide (NOx) discharge standard. In this study, an online digital image technique was applied to investigate the growth of the deposition of fly ash and ABS blend in a drop tube furnace (DTF). The deposition was measured on a temperature controlled deposition probe. The results of the image technique showed that the surface temperature of the deposition probe had a negative effect on stable thicknesses of the blend depositions and the stable thicknesses for cases 1 (553 K), 2 (513 K), and 3 (473 K) are 4.78, 5.26, and 7.64 mm, respectively. Meanwhile, the relative variation of the heat flux Q(R) for Cases 1, 2, and 3 are 17.8%, 33.8%, and 40.2%. The deposition in the lower deposition surface temperature has a greater effect on the heat transfer efficiency. In order to understand the deposition formation of fly ash and ABS blend, the X-ray diffraction (XRD), X-ray fluorescence (XRF), and the scanning electron microscopy (SEM) analysis were undertaken of the blend deposition. The results indicated that the content of ABS in the bottom part deposition increased as the probe surface temperature decreases, and this would result in more agglomerates in the deposition according to the observations of the SEM and the growth behavior of the deposition was influenced. Meanwhile, the results show that the deposition characteristics of ABS and fly ash blend is strongly influenced by the distribution and the condensation behavior of ABS. This work makes a contribution to a deeper understanding of deposition characteristics of ammonium bisulfate and fly ash blend, which is important for boilers to control the blend deposition in air preheaters and economizers.

Research on prediction model of formation temperature of ammonium bisulfate in air preheater of coal-fired power plant

Analysis of ammonium bisulfate/sulfate generation and deposition characteristics as the by-product of SCR in coal-fired flue gas

Study on the Formation Process of Low‐temperature Ash Deposition Induced by Ammonium Bisulfate in Pulverized Coal‐fired Boiler

Study on the equilibrium constants and initial formation temperature of NH4HSO4 and (NH4)2SO4 in coal‐fired flue gas

Insights into the deposition and transformation characteristics of ammonium bisulfate on the fly ash as the by-product of SCR in air preheater

Experimental Investigation of Ammonia and Sulfur Deposition Characteristics in Rotary Air Preheater

Numerical Analysis of ABS Deposition and Corrosion on a Rotary Air Preheater

A Novel Design for Reduction of Ammonium Bisulfate Deposition in the Rotary Air Preheater

Influence of Operating Conditions on Ammonium Bisulfate Deposition in the Rotary Air Preheater of Coal-Fired Power Plants

Experimental Study on the Effects of Reheat Temperatures on the Ammonium Bisulfate and Ash Blend Deposition

Status and development for detection and control of ammonium bisulfate as a by-product of SCR denitrification

Study on the Decomposition Characteristics of Ammonium Bisulfate and Fly Ash Blend Deposition During the Heating Process

NOx Prediction Model for Multi-coal Admixing Combustion in Boiler

Experimental Study on the Ash Deposit Thermal Conductivity for Ammonium Bisulfate and Fly Ash Blend with an in Situ Measurement Technology

Analysis on Ammonium Sulfate Deposition in Tail Flue of a 1000-MW Ultra-supercritical Coal-Fired Unit

Change of Ammonia Escape Rate and SO3 Conversion Rate of SCR Denitration in Full Load Range

Kinetic modelling and experimental studies on SO3 generation in flue gas for coal-fired boiler

Investigation of the Deposition Characteristics of Ammonium Bisulfate and Fly Ash Blend Using an On-Line Digital Image Technique: Effect of Deposition Surface Temperature

Experimental Study on the Effects of Calcium-Based Additives to Control Ammonium Bisulfate and Ash Mixture Deposition with an On-Line Digital Image Technique

Formation, Transformation, Measurement, and Control of SO3 in Coal-Fired Power Plants

On-Line Monitoring Of Ash Fouling For Air Pre-Heaters In Coal-Fired Power Plant Boiler