Abstract:The sulphate is an important factor restricting the efficient and stable operation of the activated coke (AC) flue gas purification system. The simulation experiments and in situ infrared tests of AC taken from desorption tower of the AC flue gas purification system were carried out to first calibrate the thermal desorption characteristics of adsorbed NH3 and sulphate and explore the reaction behaviour of NH3 with SO2 and H2SO4. On this basis, some advice for optimising the sulphate generation was put forward to improve the purification efficiency of the AC system. The results show that the temperatures of the desorption of adsorbed NH3, the decomposition of (NH4)2SO4 and NH4HSO4 are 224, 276 and 319 °C, respectively, which lays the foundation for the quantitative analysis of sulphate on AC. Regardless of the NH3 amount, only a small portion of H2SO4 is converted to sulphate, as the H2SO4 deposited in AC pores or agglomerated together could not come into contact with NH3. The final reaction product of NH3 and SO2 is mainly (NH4)2SO4 which is continuously generated because the newly generated H2SO4 is continually exposed to NH3, if NH3 is enough. The reaction of NH3 with H2SO4 takes precedence over with NH4HSO4. In the initial stages in which H2SO4 is exposed to NH3, the product is essentially all NH4HSO4 as intermediate. Then, it is further converted to (NH4)2SO4 whose amount reaches equilibrium when the accessible H2SO4 is exhausted. All the NH3 adsorbed on AC entering the desulphurisation tower generates NH4HSO4, but the amount is limited. The remaining SO2 entering the denitrification tower mainly generates (NH4)2SO4; thus, limiting the remaining SO2 amount is necessary to guarantee denitrification efficiency. When the NH3 injection is changed to the desulphurisation tower, the initial NH3 injection rate can be increased to complete the conversion of accessible H2SO4 as soon as possible in order to obtain higher denitrification efficiency.

Study on the equilibrium constants and initial formation temperature of NH4HSO4 and (NH4)2SO4 in coal‐fired flue gas

Analysis of ammonium bisulfate/sulfate generation and deposition characteristics as the by-product of SCR in coal-fired flue gas

Research on prediction model of formation temperature of ammonium bisulfate in air preheater of coal-fired power plant

Experimental Investigation on Sulfur Transformation During Coal Steam Gasification with Ca-based Absorbent

Effects of NH3 and SO3 on the generation of ammonium bisulfate and ammonium sulfate

Study on the Decomposition Characteristics of Ammonium Bisulfate and Fly Ash Blend Deposition During the Heating Process

Insights into the deposition and transformation characteristics of ammonium bisulfate on the fly ash as the by-product of SCR in air preheater

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

STUDY ON EDUCTION BEHAVIOR OF DIFFERENT SHAPE SULFUR CONTENT IN COAL UNDER HIGH TEMPERATURE

Temperature Impact on SO2 Removal Efficiency by Ammonia Gas Scrubbing

Experimental Study on the Removal of SO3 from Coal-Fired Flue Gas by Alkaline Sorbent

The Study Of Decomposition Of Calcium Sulfate With Compound Molecule At High Temperature

Research on Behavior of Sulfation Product at High Temperature

Reaction Intermediates and Products Characterisation of NH3 in Desulphurisation with Activated Coke

High-Temperature Sulfur Removal Under Fluidized-Bed Combustion Conditions - A Chemical Interpretation

The Study Of High-Temperature Stable Phase Sulphoaluminate For Desulfuration

Experimental Study on the Effects of Reheat Temperatures on the Ammonium Bisulfate and Ash Blend Deposition

Thermodynamic Analysis of Ash Mineral Phases in Combustion of High-Sulfur Coal with Lime

Kinetics for Formation of Cas As Sulphur Intermediate Retention

Research on the Adsorption Mechanism of As by Fe-bearing Minerals in Coal During High-Temperature Combustion

Sulfur Removal at High Temperature During Coal Combustion in Furnaces: A Review