Effects of NH3 and SO3 on the generation of ammonium bisulfate and ammonium sulfate

Jian-guo YANG,Wei-ying YANG,Fang-dong ZHENG,Hong ZHAO
DOI: https://doi.org/10.3969/j.issn.0253-2409.2018.01.012
2018-01-01
Journal of Fuel Chemistry and Technology
Abstract:In order to study the influence of reactant concentration on the formation of ammonium bisulfate and ammonium sulfate, a simulating flue gas system with a more accurate composition of SO3 was established. The starting temperature of ammonium bisulfate is about 230-270℃ and the peak temperature is about 180-240℃under the experimental condition. The starting temperature and peak temperature of ammonium sulfate are about 40℃ lower than that of ammonium bisulfate. The formation of ammonium bisulfate is obviously higher than that of ammonium sulfate. With different concentration and molar ratio of NH3 and SO3 , the formation rate of ammonium bisulfate is about 64%-90%, about 6-10 times of that of ammonium sulfate with about 6%-15% at 120℃. The increase of reactant concentration can promote the formation of both ammonium bisulfate and ammonium sulfate. And SO3 is more conducive to the formation of ammonium bisulfate than NH3 . Further analysis shows that the variation curve of the generation fraction of ammonium bisulfate and ammonium sulfate with temperature presents a single peak. As the reactant concentration increases, the temperature range at which the peak is located increases gradually.
What problem does this paper attempt to address?