Abstract:Sputter deposited tungsten thin films are studied by X-ray diffraction. Two phases can be identified: α -W and β -W based on the observed (110), and (200) and (210) Bragg reflections, respectively. With increasing film thickness (50 to 200 nm), the phase composition shifts from β -W towards α -W. No influence of the base pressure (3 × 10 −3 –3 × 10 −5 Pa) on the phase composition is observed. Also the influence of the argon pressure (0.3 to 0.7 Pa) is rather weak. The strongest shift towards α -W composed thin films is obtained by increasing the discharge power (50 to 250 W). This trend is further studied by energy flux measurements using a calorimetric probe. These measurements rule out a strong change of the substrate temperature, and an impact of the energy flux scaled by the deposition rate (total energy per deposited atom). Test particle Monte Carlo simulations reveal the importance of the momentum of the reflected argon neutrals on the phase composition. The maximum energy of these species is mainly defined by the discharge voltage, and is higher than the directional dependent displacement energy of W. Despite the significant correlation between phase composition and the number of displacement per deposited atom, there is a strong scatter of the phase composition. As the deposition conditions were varied in random way, changes of the target erosion profile, and the changing discharge voltage over each series are probably partially responsible for the observed scatter. This scatter is also enhanced by the long term changes in the phase composition towards the more thermodynamic stable α -W phase.

Formation conditions of the tungsten porous thin film with pulsed laser deposition under various gas atmosphere

Study on the behavior of the Plasma Plume and Film Quality using Pulsed Laser Deposition with Tungsten Target

Composition characterization of Pb(Zr,Ti)O3 (PZT) thin films prepared by pulsed laser deposition: Ambient gas and substrate position effect

A New Reactive Pulsed Laser Ablation Technique for the Deposition of Hard Carbon and Carbon-Nitride Thin Films

Experimental and Numerical Studies of Tungsten Line Growth in Laser Chemical Vapor Deposition

The Interaction of Ambient Background Gas with a Plume Formed in Pulsed Laser Deposition

Microstructure and Performance of Tungsten Coatings Prepared by Low Pressure Plasma Spraying

Erosion of Tungsten-Doped Amorphous Carbon Films in Oxygen Plasma

Observation of Substrate Orientation-Dependent Oxygen Defect Filling in Thin WO3−δ/TiO2 Pulsed Laser-Deposited Films with in Situ XPS at High Oxygen Pressure and Temperature

Small polaron formation in porous WO3−x nanoparticle films

Structural Characterization of TiO2 Thin Films Prepared by Pulsed Laser Deposition on GaAs(1 0 0) Substrates

Preparation and Electrochromic Properties of Nanocrystalline WO3 Thin Films Prepared by Pulsed Excimer Laser Ablation Technique

Laser Powder Bed Fusion of Pure Tungsten: Effects of Process Parameters on Morphology, Densification, Microstructure

Deposition of Tungsten Thin Films on Flexible Polymer Substrates by Direct-Current Magnetron Sputtering

On the Formation of Defects and Morphology During Chemical Vapor Deposition of Tungsten

Deuterium-induced Nanostructure Formation on Tungsten Exposed to High-Flux Plasma

Phase composition of sputter deposited tungsten thin films

Blistering and retention behavior of laser powder bed fused tungsten alloys under hydrogen plasma irradiation

The Influence of Filament Temperature and Oxygen Concentration on Tungsten Oxide Nanostructures by Hot Filament Metal Oxide Deposition

Observation of the Structure of Tungsten Films Prepared by MOCVD

Effects of Oxygen Partial Pressure on the Properties of ZnO Thin Films Grown on Silicon (111) Substrate by Pulsed Laser Deposition