Abstract:Solar thermal storage ceramic materials use photothermal power generation technology to store heat energy, which is an important way to use clean energy and reduce carbon emissions. In this paper, MgAl2O4 ceramics were prepared by pressureless sintering with fused magnesia and α‐Al2O3 as the primary raw materials and TiO2 as the additive. The phase composition, microstructure, physical properties, thermal shock resistance, and thermal physical properties of MgAl2O4 thermal storage ceramics were studied. The results show that the main crystalline phase of B4 is MgAl2O4 and the secondary crystalline phase is MgTi2O5. Ti4+ is dissolved into MgAl2O4 lattice, which distorts the lattice, reduces activation energy, and promotes sintering. The sample B4 (69.73 wt% α‐Al2O3, 30.27 wt% fused magnesia, and 7 wt% TiO2) sintered at 1510°C had the best comprehensive physical properties, and its bending strength and bulk density were 89.41 MPa and 3.27 g/cm3, respectively. After 30 thermal shock cycles, the bending strength of the sample B4 is slightly lost. The thermal stress generated during the expansion and contraction of the grain volume led to the decrease of the bending strength. From room temperature to 1000°C, the specific heat capacity of sample B4 is .44–1.25 J/(g·K). The heat capacity increases with the increase of temperature, and the heat storage density increases. The heat storage density is 1218.75 kJ/kg (1000°C). Heat capacity increases with temperature due to intensified lattice vibration at high temperatures. Therefore, magnesia alumina spinel ceramics show great potential in solar thermal energy storage.

Thermal shock resistance and oxidation resistance of MgAl2O4–Si3N4 ceramics for solar thermal absorber: The effects of TiO2 additive content

Sintering behavior and thermal shock resistance of aluminum titanate (Al2TiO5)-toughened MgO-based ceramics

The microstructures and properties of Fe2O3 and TiO2 co-doped corundum ceramics for solar thermal absorbing materials

Study on magnesia alumina spinel heat storage ceramics for solar thermal power generation

Preparation and thermal shock resistance of solar thermal absorbing corundum ceramics for concentrated solar power

Effect of Fe2O3–TiO2-Sm2O3 composite additive on sintering behavior and thermal properties of Al2O3 ceramics for thermal storage

Effect of Al2O3 + 4sio2 Additives on Sintering Behavior and Thermal Shock Resistance of MgO-Based Ceramics

Crystallization, sinterability, and dielectric properties of MgO–Al2O3–SiO2 glass-ceramics doped with TiO2

Effect of Al2O3 and TiO2 Addition Amount on Properties of MgO-based Ceramics by Coprecipitation Method

Preparation and properties of Al2O3/Al-2(1-0.2)Mg0.2Ti(1+0.2)O5 matrix ceramic composite

Effect of AlO + 4SiO Additives on Sintering Behavior and Thermal Shock Resistance of MgO-Based Ceramics

Enhanced high-temperature thermal stability of the novel MoAlSiN-based solar selective absorbing coatings by optimizing the multilayer structure

Preparation and characterization of mullite-silicon carbide heat absorbing ceramics for solar thermal tower plant

Effect of TiO2 Coating on Sintering Properties and Thermal Shock Properties of MgO Ceramic

Microstructure and Dielectric Properties of Novel MgTiO3-x Wt% MgAl2O4 Microwave Dielectric Composite Ceramics

Porous MgO-based ceramics synthesized by the volume expansion effect: Designing and performance

Effect of Molar Ratios of MgO/Al2O3 on the Sintering Behavior and Thermal Shock Resistance of MgOAl2O3SiO2 Composite Ceramics

Investigation of the oxidation mechanism of Si-Al2O3-fused mullite containing Ti2O3 composite

Preparation and thermal shock resistance of anorthite solar thermal energy storage ceramics from magnesium slag

Microstructures and performances of pressureless sintered MoSi2-Al2O3 composites