Abstract:Contact engineering on monolayer layer (ML) semiconducting transition metal dichalcogenides (TMDs) is considered the most challenging problem toward using these materials as a transistor channel in future advanced technology nodes. The typically observed strong Fermi-level pinning induced in part by the reaction of the source/drain contact metal and the ML TMD frequently results in a large Schottky barrier height, which limits the electrical performance of ML TMD field-effect transistors (FETs). However, at a microscopic level, little is known about how interface defects or reaction sites impact the electrical performance of ML TMD FETs. In this work, we have performed statistically meaningful electrical measurements on at least 120 FETs combined with careful surface analysis to unveil contact resistance dependence on interface chemistry. In particular, we achieved a low contact resistance for ML MoS2 FETs with ultrahigh-vacuum (UHV, 3 × 10-11 mbar) deposited Ni contacts, ∼500 Ω·μm, which is 5 times lower than the contact resistance achieved when deposited under high-vacuum (HV, 3 × 10-6 mbar) conditions. These electrical results strongly correlate with our surface analysis observations. X-ray photoelectron spectroscopy (XPS) revealed significant bonding species between Ni and MoS2 under UHV conditions compared to that under HV. We also studied the Bi/MoS2 interface under UHV and HV deposition conditions. Different from the case of Ni, we do not observe a difference in contact resistance or interface chemistry between contacts deposited under UHV and HV. Finally, this article also explores the thermal stability and reliability of the two contact metals employed here.

Dipole-induced Ohmic contacts between monolayer Janus MoSSe and bulk metals

Design of ohmic contacts between Janus MoSSe and two-dimensional metals

Ohmic contacts in MXene/MoSi2N4 heterojunctions

Contact engineering for 2D Janus MoSSe/metal junctions

Utilizing the Janus MoSSe surface polarization in designing complementary metal-oxide-semiconductor field-effect transistors

Designing Barrier-Free Metal/MoS 2 Contacts through Electrene Insertion

4H-SiC Ohmic contacts formation by MoS2 layer intercalation: A first-principles study

The Contact Properties of Monolayer and Multilayer MoS2-Metal van der Waals Interfaces

Influence of MoS 2 -metal interface on charge injection: a comparison between various metal contacts

Designing electrical contacts to MoS$_2$ monolayers: A computational study

P-type Ohmic contact to MoS2 via binary compound electrodes

Asymmetric Schottky Contacts in van der Waals Metal-Semiconductor-Metal Structures Based on Two-Dimensional Janus Materials

Low Contact Resistance on Monolayer MoS2 Field-Effect Transistors Achieved by CMOS-Compatible Metal Contacts

Interfacial Properties of Monolayer and Bilayer MoS 2 Contacts with Metals: Beyond the Energy Band Calculations

Two-dimensional van der Waals electrical contact to monolayer MoSi$_2$N$_4$

Interfacial Properties of Monolayer and Bilayer MoS2 Contacts with Metals: Beyond the Energy Band Calculations

Designing Efficient Metal Contacts to Two-Dimensional Semiconductors MoSi$_2$N$_4$ and WSi$_2$N$_4$ Monolayers

Metal Contacts On Physical Vapor Deposited Monolayer Mos

Electrical contacts to few-layer MoS 2 with phase-engineering and metal intercalation for tuning the contact performance

P-type Ohmic contacts of MBenes with MoS2 for nanodevices and logic circuits