Abstract:Crystalline silicon (c-Si) solar cells with passivation stacks consisting of a polycrystalline silicon (poly-Si) layer and a thin interfacial silicon dioxide (SiO2) layer show high conversion efficiencies. Since the poly-Si layer in this structure acts as a carrier transport layer, high doping of the poly-Si layer is crucial for high conductivity and the efficient transport of charge carriers from the bulk to a metal contact. In this respect, conventional furnace-based high-temperature doping methods are limited by the solid solubility of the dopants in silicon. This limitation particularly affects p-type doping using boron. Previously, we showed that laser activation overcomes this limitation by melting the poly-Si layer, resulting in an active concentration beyond the solubility limit after crystallization. High electrically active boron concentrations ensure low contact resistivity at the (contact) metal/semiconductor interface and allow for the maskless patterning of the poly-Si layer by providing an etch-stop layer in an alkaline solution. However, the high doping concentration degrades during long high-temperature annealing steps. Here, we performed a test of the stability of such a high doping concentration under thermal stress. The active boron concentration shows only a minor reduction during SiNx:H deposition at a moderate temperature and a fast-firing step at a high temperature and with a short exposure time. However, for an annealing time tanneal = 30 min and an annealing temperature 600 °C ≤ Tanneal≤ 1000 °C, the high conductivity is significantly reduced, whereas a high passivation quality requires annealing in this range. We resolve this dilemma by introducing a second, healing laser reactivation step, which re-establishes the original high conductivity of the boron-doped poly-Si and does not degrade the passivation. After a thermal annealing temperature Tanneal = 985 °C, the reactivated layers show high sheet conductance (Gsh) with Gsh = 24 mS sq and high passivation quality, with the implied open-circuit voltage (iVOC) reaching iVOC = 715 mV. Therefore, our novel three-step process consisting of laser activation, thermal annealing, and laser reactivation/healing is suitable for fabricating highly efficient solar cells with p++-poly-Si/SiO2 contact passivation layers.

Demonstration of c-Si solar cells with gallium oxide surface passivation and laser-doped gallium p+ regions

Gallium‐Doped Silicon for High‐Efficiency Commercial Passivated Emitter and Rear Solar Cells

Ga-doped Czochralski silicon with rear p-type polysilicon passivating contact for high-efficiency p-type solar cells

24.2% efficient POLO back junction solar cell with an AlOx/SiNy dielectric stack from an industrial‐scale direct plasma‐enhanced chemical vapor deposition system

Three-Step Process for Efficient Solar Cells with Boron-Doped Passivated Contacts

ALD Al2O3 based nanolaminates for solar cell applications

Enhanced Si Passivation and PERC Solar Cell Efficiency by Atomic Layer Deposited Aluminum Oxide with Two-step Post Annealing

Light-soaking Enhanced Passivation of Al2O3 on Crystalline Silicon Surface

Direct evidence for grain boundary passivation in Cu(In,Ga)Se2 solar cells through alkali-fluoride post-deposition treatments

Improved Silicon Surface Passivation by ALD Al2O3/SiO2 Multilayers with In‐Situ Plasma Treatments

Surface Passivation of III-V GaAs Nanopillars by Low Frequency Plasma Deposition of Silicon Nitride for Active Nanophotonic Devices

Investigation on the passivated Si/Al2O3 interface fabricated by non-vacuum spatial atomic layer deposition system

Enhanced surface passivation of GaAs nanostructures via an optimized SiO2 sol-gel shell growth

Silicon Ion Implant Activation in β-(Al0.2Ga0.8)2O3

Significant Passivation Effect of Cu(In, Ga)Se 2 Solar Cells via Back Contact Surface Modification Using Oxygen Plasma

High-performance sub-micron CIGSSe solar cells optimized for sodium doping by adjusting diffusion barriers

Laser Crystallization and Dopant Activation for a-Si:H Film in Carrier-Selective Contacts for Silicon Solar cells

Highly reflective and passivated ohmic contacts in p-Ge by laser processing of aSiCx:H(i)/Al2O3/aSiC films for thermophotovoltaic applications

Growth of gallium cerium oxide passivation layer on 4H-Silicon carbide substrate and its metal-oxide-semiconductor characteristics

High‐Performance and Industrially Viable Nanostructured SiO x Layers for Interface Passivation in Thin Film Solar Cells

Gallium Diffusion in Cigs Thin Films Prepared by Sequential Sputtering/Selenization Technique