Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Study on dynamic behavior of tubular T-joints subjected to out-of-plane impact loading

Dynamic Behavior of CHS-SHS Tubular T-joints Subjected to Low-Velocity Impact Loading

Axial Impact Behaviors of Stub Concrete-Filled Square Steel Tubes

Flexural behavior of concrete-filled circular steel tubes under high-strain rate impact loading

Experimental study of the static behavior of tubular N-joints

Experimental and numerical study on the dynamic behavior of concrete-filled double steel tubular T-joint under impact loading

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Experimental and numerical study on static behaviour of uniplanar CFDST-CHS T-joints

Study on In-Plane Behavior of Thin-walled Concrete-filled Steel Tubular Gusset Plate T-joints

Behaviour Of Concrete-Filled Tubular T-Joints Under In-Plane Bending Cyclic Loading

Numerical Study Of Stainless Steel Circular Hollow Section Tubular T-Joints

Design of concrete filled tubular CHS T-joints under in-plane bending

Experimental study and numerical analysis on the dynamic response of steel tube confined concrete with a circular hollow section (STCC-CHS) under transverse impact loading

Concrete-Filled Steel and Steel Tubular T-Joints under Cyclic In-Plane Bending

Study of energy dissipation mechanism of concrete-filled steel tubular T-joints

Hysteretic Behaviour of Tubular Joints under Cyclic Loading

Numerical Study And Design Of Austenitic Stainless Steel Tubular T- And Y- Joints In Circular Hollow Sections

Experimental study on axially preloaded circular steel tubes subjected to low-velocity transverse impact

Dynamic Behavior of Scaled Tubular K-joints Subjected to Impact Loads

Investigations on Stainless Steel T- and Y-joints in Cold-Rolled Circular Hollow Sections

Behaviour of Grout-Filled Double-Skin Steel Tubular T-joint Subjected to Low-Velocity Impact