Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Experimental and numerical study on the dynamic behavior of concrete-filled double steel tubular T-joint under impact loading

Flexural behavior of concrete-filled circular steel tubes under high-strain rate impact loading

Behavior Of Concrete Filled Tubes And Confined Concrete Filled Tubes Under High Speed Impact

Experimental study of the static behavior of tubular N-joints

Behaviour of CFT and CCFT columns under impact loads

Study of energy dissipation mechanism of concrete-filled steel tubular T-joints

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Dynamic Responses of Jacket Foundation Offshore Wind Turbine Considering the Cyclic Loading Effects

Dynamic Behavior of CHS-SHS Tubular T-joints Subjected to Low-Velocity Impact Loading

Behaviour of Grout-Filled Double-Skin Steel Tubular T-joint Subjected to Low-Velocity Impact

Concrete-Filled Steel and Steel Tubular T-Joints under Cyclic In-Plane Bending

Study on dynamic behavior of tubular T-joints subjected to out-of-plane impact loading

Behaviour Of Concrete-Filled Tubular T-Joints Under In-Plane Bending Cyclic Loading

Experimental study and numerical analysis on the dynamic response of steel tube confined concrete with a circular hollow section (STCC-CHS) under transverse impact loading

Dynamic Behavior of Scaled Tubular K-joints Subjected to Impact Loads

Experimental Investigation On Circular Cfdst Chord To Chs Brace T-Joints

Investigation on the Lateral Impact Responses of Circular Concrete-Filled Double-Tube (CFDT) Members

Experimental Behavior of Concrete Filled Double Steel Tubular (CFDST) Members under Low Velocity Drop Weight Impact

Experimental and numerical study on static behaviour of uniplanar CFDST-CHS T-joints

Static behavior of stiffened CFST KK joints of offshore wind turbines under antisymmetric loading

Dynamic Responses of Thin-Walled FRP-concrete-steel Tubular Wind Turbine Tower under Horizontal Impact Loading: Experimental Study and FE Modelling