Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Experimental study of the static behavior of tubular N-joints

Experimental Investigation of X-joint in Double-Arch Structure

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Experimental Study on the Axial Compressive Strength of Vertical Inner Plate Reinforced Square Hollow Section T-joints

Behaviour Of Concrete-Filled Tubular T-Joints Under In-Plane Bending Cyclic Loading

Full-scale experimental research on tubular N-joints of square chords with circular braces

Concrete-Filled Steel and Steel Tubular T-Joints under Cyclic In-Plane Bending

Design of concrete filled tubular CHS T-joints under in-plane bending

Experiment investigations of stress concentration factor of concrete-filled tubular T joints

Study on In-Plane Behavior of Thin-walled Concrete-filled Steel Tubular Gusset Plate T-joints

02.05: Design of concrete-filled steel tubular longitudinal gusset plate connections

Experimental Investigation of Concrete-Filled Steel Tubular Longitudinal Gusset Plate Connections

Study of energy dissipation mechanism of concrete-filled steel tubular T-joints

Study on tensile performance of doubler plate reinforced T-joints with circular chord and brace

Experimental Comparison of Static Behavior of Tubular Joints Welded in Different Ways

Experimental Research on Rectangular Steel Tube X-joints with Chord Concrete-Inside Subjected to Tension and Bending

EXPERIMENTAL STUDY ON THE MECHANIC BEHAVIOR OF UNSTIFFENED STEEL TUBULAR X-JOINT

EXPERIMENT ON STATIC BEARING CAPACITY OF MULTI-PLANAR INTERNALLY STIFFENED CHS TUBULAR JOINTS

Experimental studies on mechanical behavior of circular tubed reinforced concrete joints with ring ribs

Experimental and numerical study on static behaviour of uniplanar CFDST-CHS T-joints

Experimental study of type and Y-type joints of the concrete-fillled rectangular steel tube truss