Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Full-scale experimental research on tubular N-joints of square chords with circular braces

Experimental study of the static behavior of tubular N-joints

Experimental Investigation of X-joint in Double-Arch Structure

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Experimental Study on the Axial Compressive Strength of Vertical Inner Plate Reinforced Square Hollow Section T-joints

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Static performance of square CFDST chord to steel SHS brace T-joints

Design of CHS brace-to-H-shaped chord T-joints under axial compression

An Experimental Study on Stainless Steel Hybrid Tubular Joints with Square Braces and Circular Chord

Influence of Chord Stress on Axial Strength of Rectangular Tubular TX- and XX-joints

Design of concrete filled tubular CHS T-joints under in-plane bending

Experimental Research on Cave-in Ultimate Bearing Capacity of Grouted-Round-steel Tube

Experimental and numerical study on static behaviour of uniplanar CFDST-CHS T-joints

Experiments on Hybrid Tubular K-joints with Circular Braces and Square Chord in Stainless Steel

Nonlinear Finite Element Analysis of Ultimate Strength on Tubular K-Joints:Square Chords and Circular Braces

Effects of Chord Pre-Load on Strength of CHS X-joints Stiffened with External Ring Stiffeners and Gusset Plates

Behaviour of Chs Brace-To-H-Shaped Chord X-Joints under In-Plane Bending

Load Introduction and Transfer Mechanism of K-type CFST Circular Section Connections

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Tests of SHS Brace-H-shaped Chord X-joints under In-Plane Bending

Experimental study and FEM analysis on mechanical behavior of a steel tubular joint with bolted connection subject to biaxial compression