Abstract:Polycrystalline diamond compacts (PDCs) are the main cutting unit of drill bits and are a major factor in determining the drilling efficiency and service life of drill bits. Drill bit failure is caused by the severe abrasive wear it undergoes during the drilling process. The drill bit failure can prolong the drilling period, which can result in borehole instability and cause collapse in the material. A solution that can address this issue is developing an appropriate drilling method that can expel the dust in a manner that will not increase the abrasive wear on the drill bit. Here, an Amsler friction and wear-testing machines was used to investigate the friction and wear characteristics of PDC and to study the effects of the dust expelled during drilling on the wear performance of drill bits under dry air and wetting conditions. The microstructures of the worn surfaces were examined by a scanning electron microscope (SEM) and metalloscope. In addition, the chemical compositions of the PDCs' surfaces were analyzed using X-ray diffraction (XRD) after the wear and friction tests. The results demonstrate that the friction coefficients and wear rate obtained in dry air were higher than those under wetting conditions. As expected, these values are mainly ascribed to the absence of the absorber layer and lubrication under dry air. Furthermore, under wetting conditions a number of cracks were observed on the PDC surface after testing at 700 °C, which was mainly caused by two factors: The different thermal expansion coefficients between the diamond and Cobalt phase; and the residual stress generated inside the PDC under wetting conditions.

Friction and wear characteristics of agglomerated diamond abrasives and lapping performance of fixed agglomerated diamond pads

Lapping performance of mixed-size agglomerated diamond abrasives in fixed abrasives pads

A novel agglomerated diamond abrasive with excellent micro-cutting and self-sharpening capabilities in fixed abrasive lapping processes

Tribological effects of loose alumina abrasive assisted sapphire lapping by a fixed agglomerated diamond abrasive pad (FADAP)

In-situ reconditioning mechanism for fixed abrasive pads based on the wear behavior of loose grains

Amorphous Diamond Dresser for CMP Fixed Abrasives Pad

Influence of Binding Agent on the Cutting Performance and Friction Wear Characteristics of Catalytic Composite Abrasive Cluster

Influence of holding time on the interfacial solid solution and mechanical properties of agglomerated white fused alumina abrasives

Analysis of Fixed Abrasive Pads with a Nano-Sized Diamond for Silicon Wafer Polishing

The Wear and Friction Characters of Polycrystalline Diamond under Wetting Conditions

Research on the Fixed-Abrasive Lapping Process of Polycrystalline Aluminum Nitride

Analysis of Abrasives on Cutting Edge Preparation by Drag Finishing

Study on the CMP Pad Life with Its Mechanical Properties

Effect of Abrasive Grain Concession on Micromechanical Behavior of Lapping Sapphire by FAP

Friction and wear behaviors of polycrystalline diamond self-mated pairs in air and water lubrication conditions

Fabrication and Grinding Performance of CVD Diamond Abrasive Tool

Effect of particle size on friction signal characters when lapping quartz glass with fixed abrasive pad

An Exploration of the Influence of Abrasive Water Jet Pressure on the Friction Signal Characteristics of Fixed Abrasive Lapping Quartz Glass Based on HHT

Pad surface and coefficient of friction correlation analysis during friction between felt pad and single-crystal silicon

Novel Abrasive-Impregnated Pads and Diamond Plates for the Grinding and Lapping of Single-Crystal Silicon Carbide Wafers

Dependence of Wear Behaviors of Hardmetal Yg8b on Coarse Abrasive Types and Their Slurry Concentrations