Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Analysis of suppression switching overvoltage for CRAFT power supply

Current Saturation Analysis and Anti-Windup Control Design of Grid-Forming Voltage Source Converter

Analysis on Overvoltage in Renovated Control and Protection System for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Mechanism and Application Analysis of Rectification-bridge Type Over-voltage Suppression Equipment

Study on Switching Over-voltage and Its Restrictions in UHVAC System

Modeling and Overvoltage Suppression Analysis of Grid-connected Converter with VSG Control Strategy under Commutation Failure

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station

Analysis of Switching Transient Overvoltage and EMC Design of the ShengGuang-III Power Conditioning System

Novel Method for Restraining 35 Kv Shunt Reactor Switching Overvoltage – Phase Controlled Breaker

DC switching overvoltage of ± 1100 kV UHVDC converter station

Analysis on Feasibility for Deeply Suppressing Switching Overvoltage in AC UHV Systems

Snubber and Metal Oxide Varistor Optimization Design of Modular IGCT Switch for Overvoltage Suppression in Hybrid DC Circuit Breaker

Analysis and verification of electrodynamic force, thermal stress and current sharing for CRAFT converter structure design

Analysis and Suppression of Voltage Overshoot in Symmetrical Hybrid Five-level Converter

Research on Overvoltage Suppression by Blocking Diode and DC Circuit Breaker in LCC-VSC Hybrid HVDC System.

Research on Short Circuit Operation Control Strategy of a Superconducting Magnet Power Supply for CRAFT

Deeply suppressing switching overvoltage of 1000kV ac ultra-high voltage system

Deep Suppression of Switching Overvoltages in AC UHV Systems Using Low Residual Arresters

Overvoltage Suppression for Modular Multilevel Converter with Switch Open-Circuit Fault

Overvoltage Suppression Under Commutation Failure Based on Improved Voltage-Dependent Current Order Limiter Control Strategy