Abstract:This paper presents a high quality-factor (Q-factor) quartz tuning fork (QTF) with a glass probe attached, used in frequency modulation tapping mode atomic force microscopy (AFM) for the surface profile metrology of micro and nanostructures. Unlike conventionally used QTFs, which have tungsten or platinum probes for tapping mode AFM, and suffer from a low Q-factor influenced by the relatively large mass of the probe, the glass probe, which has a lower density, increases the Q-factor of the QTF probe unit allowing it to obtain better measurement sensitivity. In addition, the process of attaching the probe to the QTF with epoxy resin, which is necessary for tapping mode AFM, is also optimized to further improve the Q-factor of the QTF glass probe. The Q-factor of the optimized QTF glass probe unit is demonstrated to be very close to that of a bare QTF without a probe attached. To verify the effectiveness and tire advantages of the optimized QTF glass probe unit, the probe unit is integrated into a home-built tapping mode AFM for conducting surface profile measurements of micro and nanostructures. A blazed grating with fine tool marks of 100nm, a microprism sheet with a vertical amplitude of 25 mu m and a Fresnel lens with a steep slope of 90 degrees are used as measurement specimens. From the measurement results, it is demonstrated that the optimized QTF glass probe unit can achieve higher sensitivity as well as better stability than conventional probes in the measurement of micro and nanostructures.

High quality factor measured in fused silica

High Quality-Factor Quartz Tuning Fork Glass Probe Used In Tapping Mode Atomic Force Microscopy For Surface Profile Measurement

High Mechanical Quality Factor of Calcium Fluoride (caf2) at Room Temperature

Effect of annealing on mechanical quality factor of fused quartz hemispherical resonator

Six million Q factor micro fused silica shell resonator with teeth-like tines released by femtosecond laser-assisted chemical etching

Greater Than One Billion Q Factor for On-Chip Microresonators

Ultrahigh Quality Factor of a Levitated Nanomechanical Oscillator

Nanotube mechanical resonators with quality factors of up to 5 million

Ultra-high quality factor of a levitated nanomechanical oscillator

On-chip Q-factor Greater Than 1 Billion

High Quality 3-Dimensional Aluminum Microwave Cavities

Strain-enhanced high Q -factor GaN micro-electromechanical resonator.

Novel Method to Measure Unloaded Quality Factor of Resonant Cavities at Room Temperature

Strain-enhanced high<i>Q</i>-factor GaN micro-electromechanical resonator

High-quality-factor photonic crystal ring resonator.

High Mechanical Q-factor Measurement of Si Using a 3D Cantilever Support.

Higher-order resonance of single-crystal diamond cantilever sensors toward high f‧Q products

A Three Million Q Factor Tuning Fork Resonator Based on a Vibration Isolation Structure

Fabrication and Characterization of a High Q-Factor Microcantilever Enhanced by Lead Zirconate Titanate Thick Film

Optical probing of mechanical loss of a Si_{3}N_{4} membrane below 100 mK

High quality factor Si 3 N 4 ring resonators achieved by surface roughness reduction