Abstract:Micromechanical and nanomechanical systems with exceptionally low dissipation rates are enabling the next-generation technologies of ultrasensitive detectors and quantum information systems. New techniques and methods for lowering the dissipation rate have in recent years been discovered and allowed for the engineering of mechanical oscillators with phononic modes that are extremely well isolated from the environment and thus possess quality factors close to and beyond 1×109 . A powerful strategy for isolating and controlling a single phononic mode is based on phononic crystal engineering. Here we propose a new method for phononic crystal engineering of nanomechanical oscillators that is based on a periodic variation of the material density. To circumvent the introduction of additional bending losses resulting from the variation of material density, the added mass constitutes an array of nanopillars in which the losses will be diluted. Using this novel technique for phononic crystal engineering, we design and fabricate corrugated mechanical oscillators with quality factors approaching 1×109 in a room temperature environment. The flexibility space of these new phononic crystals is large and further advancement can be attained through optimized phononic crystal patterning and strain engineering via topology optimization. This will allow for the engineering of mechanical membranes with quality factors beyond 1×109 at room temperature. Such extremely low mechanical dissipation rates will enable the development of radically new technologies such as quantum-limited atomic force microscopy at room temperature, ultrasensitive detectors of dark matter, spontaneous waveform collapses, gravity, and high-efficiency quantum information transducers. https://doi.org/10.1103/PhysRevX.14.011039 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Published by the American Physical Society

Ultra-high quality factor of a levitated nanomechanical oscillator

Ultrahigh Quality Factor of a Levitated Nanomechanical Oscillator

An ultra-narrow line width levitated nano-oscillator for testing dissipative wavefunction collapse

Thermal nonlinearities in a nanomechanical oscillator

Mechanical Dissipation Below 1 μ Hz with a Cryogenic Diamagnetic Levitated Micro-Oscillator

Mechanical Dissipation below 1μhz with a Cryogenic Diamagnetic-Levitated Micro-Oscillator

Ultra-Low Dissipation Superfluid Micromechanical Resonator

High-purity quantum optomechanics at room temperature

Nanotube mechanical resonators with quality factors of up to 5 million

Ultracoherent Nanomechanical Resonators Based on Density Phononic Crystal Engineering

Suppressing Mechanical Dissipation of Diamagnetically Levitated Oscillator Via Engineering Conductive Geometry

Ultralow Mechanical Damping with Meissner-Levitated Ferromagnetic Microparticles

Morphological tracking and tuning of silica NPs for stable levitation in vacuum optomechanical systems

A low-frequency superconductor oscillator with a 10^10-quality factor

Optically Levitated Nanodumbbell Torsion Balance and GHz Nanomechanical Rotor.

Magneto-quantum-nanomechanics: ultra-high Q levitated mechanical oscillators

Spinning a levitated mechanical oscillator far into the deep-strong coupling regime

Dynamics of levitated nanospheres: towards the strong coupling regime

Ultra-coherent nanomechanical resonators based on density phononic crystal engineering

Sensing weak force using a diamagnetic levitated micromechanical oscillator

Ultrahigh-quality-factor micro- and nanomechanical resonators using dissipation dilution