Abstract:Micromechanical and nanomechanical systems with exceptionally low dissipation rates are enabling the next-generation technologies of ultrasensitive detectors and quantum information systems. New techniques and methods for lowering the dissipation rate have in recent years been discovered and allowed for the engineering of mechanical oscillators with phononic modes that are extremely well isolated from the environment and thus possess quality factors close to and beyond 1×109 . A powerful strategy for isolating and controlling a single phononic mode is based on phononic crystal engineering. Here we propose a new method for phononic crystal engineering of nanomechanical oscillators that is based on a periodic variation of the material density. To circumvent the introduction of additional bending losses resulting from the variation of material density, the added mass constitutes an array of nanopillars in which the losses will be diluted. Using this novel technique for phononic crystal engineering, we design and fabricate corrugated mechanical oscillators with quality factors approaching 1×109 in a room temperature environment. The flexibility space of these new phononic crystals is large and further advancement can be attained through optimized phononic crystal patterning and strain engineering via topology optimization. This will allow for the engineering of mechanical membranes with quality factors beyond 1×109 at room temperature. Such extremely low mechanical dissipation rates will enable the development of radically new technologies such as quantum-limited atomic force microscopy at room temperature, ultrasensitive detectors of dark matter, spontaneous waveform collapses, gravity, and high-efficiency quantum information transducers. https://doi.org/10.1103/PhysRevX.14.011039 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Published by the American Physical Society

Mechanical Dissipation Below 1 μ Hz with a Cryogenic Diamagnetic Levitated Micro-Oscillator

Mechanical Dissipation below 1μhz with a Cryogenic Diamagnetic-Levitated Micro-Oscillator

Sensing weak force using a diamagnetic levitated micromechanical oscillator

Suppressing Mechanical Dissipation of Diamagnetically Levitated Oscillator Via Engineering Conductive Geometry

Ultra-Low Dissipation Superfluid Micromechanical Resonator

Ultrahigh Quality Factor of a Levitated Nanomechanical Oscillator

Ultra-high quality factor of a levitated nanomechanical oscillator

Ultralow Mechanical Damping with Meissner-Levitated Ferromagnetic Microparticles

Ultralow Dissipation Nanomechanical Devices from Monocrystalline Silicon Carbide

Ultracoherent Nanomechanical Resonators Based on Density Phononic Crystal Engineering

Suppression of Damping in a Diamagnetically Levitated Dielectric Sphere Via Eddy Currents and Static Charge Reduction.

Magneto-quantum-nanomechanics: ultra-high Q levitated mechanical oscillators

Lens-free Optical Detection of Thermal Motion of a Sub-millimeter Sphere Diamagnetically Levitated in High Vacuum

Lens-Free Optical Detection of Thermal Motion of a Submillimeter Sphere Diamagnetically Levitated in High Vacuum

Ultra-coherent nanomechanical resonators based on density phononic crystal engineering

Sub-Kelvin Cooling of a Macroscopic Oscillator and femto-Newton Force Measurement

Strained crystalline nanomechanical resonators with ultralow dissipation

Room temperature test of the continuous spontaneous localization model using a levitated micro-oscillator

Ground-state Cooling of a Magnomechanical Resonator Induced by Magnetic Damping

A superconducting quantum interference device based read-out of a subattonewton force sensor operating at millikelvin temperatures

Resolved Sideband Cooling of a Micromechanical Oscillator