Abstract:Carbon nanotube field-effect transistors (CNT FETs) have been demonstrated to exhibit high performance only through low-temperature fabrication process and require a low thermal budget to construct monolithic three-dimensional (M3D) integrated circuits (ICs), which have been considered a promising technology to meet the demands of high-bandwidth computing and fully functional integration. However, the lack of high-quality CNT materials at the upper layer and a low-parasitic interlayer dielectric (ILD) makes the reported M3D CNT FETs and ICs unable to provide the predicted high performance. In this work, we demonstrate a multilayer stackable process for M3D integration of high-performance aligned carbon nanotube (A-CNT) transistors and ICs. A low-kappa (similar to 3) interlayer SiO2 layer is prepared from spin-on-glass (SOG) through processes with a highest temperature of 220 C-degrees, presenting low parasitic capacitance between two transistor layers and excellent planarization to offer an ideal surface for the A-CNT and device fabrication process. A high-quality A-CNT film with a carrier mobility of 650 cm(2) V-1 s(-1) is prepared on the ILD layer through a clean transfer process, enabling the upper CNT FETs fabricated with a low-temperature process to exhibit high on-state current (1 mA mu m(-1)) and peak transconductance (0.98 mS mu m(-1)). The bottom A-CNT FETs maintain pristine high performance after undergoing the ILD growth and upper FET fabrication. As a result, 5-stage ring oscillators utilizing the M3D architecture show a gate propagation delay of 17 ps and an active region of approximately 100 mu m(2), representing the fastest and the most compact M3D ICs to date.

Monolithic-3D Integration with 2D Materials: Toward Ultimate Vertically-Scaled 3D-ICs

Monolithic Three‐dimensional Integration of Aligned Carbon Nanotube Transistors for High‐performance Integrated Circuits

Monolithic three-dimensional integration of complementary two-dimensional field-effect transistors

Towards 3-D Carbon-Based Heterogeneous Interconnects

Mono 3 D to Develop Large-Scale Monolithic 3 D Integrated Circuits

Monolithic three-dimensional tier-by-tier integration via van der Waals lamination

Monolithic 3D integration with 2D materials

Heterogeneous Monolithic 3-D IC Designs: Challenges, EDA Solutions, and Power, Performance, Cost Tradeoffs

Skybridge-3D-CMOS: A Vertically-Composed Fine-Grained 3D CMOS Integrated Circuit Technology

Monolithic 3D integration of back-end compatible 2D material FET on Si FinFET

Monolithic and heterogeneous three-dimensional integration of two-dimensional materials with high-density vias

Three-Dimensional Integrated Circuits and the Future of System-on-Chip Designs

Monolithic 3D integration of 2D materials-based electronics towards ultimate edge computing solutions

The development of integrated circuits based on two-dimensional materials

Physical Design of Monolithic 3 D ICs with Applications to Hardware Security

Technologies for 3D Heterogeneous Integration

Open Source Cell Library Mono3D to Develop Large-Scale Monolithic 3D Integrated Circuits.

Comprehensive Physical Design Flow Incorporating 3D Connections for Monolithic 3D ICs

Three-dimensional Integrated Circuits: Design, EDA, and Architecture

Thermal Evaluation for Monolithic 3D Integrated Circuits Based on Gate-all-Around Transistors

Mono3D: Open Source Cell Library for Monolithic 3-D Integrated Circuits.