Abstract:The creation of the cyclotron absolutely sited radio frequency at the centre of particle accelerators. In the cyclotron, RF system is a device that transforms electrical energy taken from the grid into energy transferred to a beam of particles inside the accelerating cavity. The power coupler, which transport and inject power to the cavity, needs at the same time to couple strongly the transmission line to the field distribution in the cavity. It also has to provide a way to adjust the matching between the line and the cavity, and finally to separate the vacuum of the cavity from the air of the line. The consequence of these multiple requirements is that the power coupler is usually a very critical device that requires a careful design and prototyping. R.F window is one of the main parts of the power coupling capacitor. The present research work dealt with the simulation of R.F window brazing process & development of ceramic to metal (copper) outer joint of R.F window. The outer brazing joint is very critical as higher thermal expansion material, e.g. copper is placed outside of the lower linear thermal expansion coefficient material (ceramic). It results a large brazing gap – not suitable for capillary action. A detailed analysis was performed from simple model to FEM model (using theoretical approach & FEM code, Ansys.) to understand the behavior during brazing. Molybdenum & Graphite both had been considered separately as tooling fixture material for theoretical and FEM analysis. Literature review reported that maximum work in the field of ceramic to metal brazing have been adopted using molybdenum as tooling fixture. In this research work Graphite was selected as tooling fixture material to perform the vacuum brazing process of ceramic to copper outer joint test model. After design and dimensions, model drawings were developed. Fabrication of the test model assembly, brazed inside vacuum brazing furnace by using Cusil filler. This joint has qualified Helium leak test in order of 3.6 X 10-9 mbar l/s.

FEM Simulation of ITER EC H&CD Diamond Microwave Window Unit during Preparation and Subsequent Service

Progress of High Heat Flux Component Manufacture and Heat Load Experiments in China

Study on the Microstructure and Properties Evolution of CuCrZr/316LN-IG Explosion Bonding for ITER First Wall Components

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

China’s Technological Achievements on ITER Enhanced Heat Flux First Wall in the Pre-Pa Qualification

Thermal fatigue failure behavior on Be/Cu joint of ITER first wall after enhanced heat flux test

Microstructural analysis of the thermal fatigue tested Be/CuCrZr joint with artificial defects between Ti/Cu interlayers

Stress Analysis and Design of Dielectric Microwave Transmission Window for Microwave Chemical Reactors

Investigation of a Large Power Water-Cooled Microwave Resonance Window for Application with the ECR Ion Source

Diamond Window Technology for Electron Cyclotron Heating and Current Drive: State of the Art

Design and analysis of radio frequency window for the China Fusion Engineering Test Reactor ion cyclotron range of frequency heating system

Mechanical and Thermal Analysis of Beryllium Windows for RF Cavities in a Muon Cooling Channel

Plasma Facing Component with Built-in Tungsten Wires and a W-Cu Functionally Graded Layer: A Finite Element Assessment

Design of High Power Microwave Ceramic Windows in C-Band

Experimental and simulation studies on damage mechanisms of tungsten and molybdenum under compressed plasma flow irradiation

Simulation and experimental research on the substrate temperature distribution in HFCVD diamond film growth on the inner hole surface

Exploring of Two Connection Forms of the Tungsten Tile and CuCrZr Heat Sink for First Wall Mockup

Development of RF windows for 650 MHz multibeam klystron

Expression of Concern: Effect of Heat Treatment on the Properties of Electron Beam Welded Joint of First Wall

Updated Thermal-Mechanical Analysis of DFLL-TBM for ITER

Simulation of R.F window Brazing process: Thermal-Structural analysis of ceramic to metal vacuum brazing joints