Abstract:A thorough understanding of the reactor core thermal hydraulic behavior is essential for the design and safety analysis of Sodium-cooled Fast Reactors (SFR). Due to the application of hexagonal subassembly, the core thermal hydraulic behavior is significantly affected by the flow field within the subassemblies, the inter-wrapper region and the hot pool. Analysis of the core thermal hydraulic behavior requires a model coupling the three regions mentioned above, which has been identified as one of the thermal hydraulic challenges in SFR. In the present study, a 3D model that covers the three regions was developed for the core of the China Experimental Fast Reactor (CEFR) with the Computational Fluid Dynamic (CFD) code, Fluent. The inter-wrapper region and the hot pool were modeled in detail, while the subassemblies were modeled with a special porous medium model. The core thermal hydraulics behavior under steady state was studied, more specifically, information for the flow field distribution at the core outlet, the inter-wrapper flow and the duct wall temperature distribution was obtained. Under steady state, liquid sodium in the inter-wrapper region is supplied by the inner region of the hot pool. And it enters the inter-wrapper region from the core outer region and returns back to the hot pool inner region from the core central region. The inter-wrapper flow is cooled by non-fuel subassemblies and heated up by fuel subassemblies. For non-fuel subassembly, the ratio of the total heat transfer rate between the inter-wrapper flow and the subassemblies to the heat generated within subassemblies could reaches 96%; for fuel subassemblies, the maximum ratio of the total heat transfer rate between the inter-wrapper flow and the subassemblies to the heat generated within subassemblies is 2.45%. Significant temperature gradients have been observed on the duct wall, with maximum values of 156.69 K/m in the vertical direction and 2,196.00 K/m in the circumferential direction. The largest temperature gradient appears on the duct of subassemblies adjacent to the transition region of fuel subassemblies and non-fuel subassemblies.

Research on thermal hydraulic characteristics of reflooding process based on core multi-channel model in system analysis code

Reflooding characteristics investigation and predicted models improvement for the pressurized water reactor with the tight lattice core design

Numerical investigation of transient hydrodynamic properties during reflood with early power termination using the COSINE subchannel code

Early Mitigation Measures for High Flux Reactor Loss-of-Coolant Accidents

Numerical Simulation of AP1000 LBLOCA with SCDAP/RELAP 4.0 Code

Development and assessment of a three-field subchannel code for thermo-hydraulic transient analysis under reflood conditions

Numerical analysis of reflood heat transfer and large-break LOCA including CRUD layer thermal effects

Analytical Studies of Long-Term IRWST Injection Core Cooling under Small Break LOCA in Passive Safety PWR

Experimental investigation on transition boiling during reflooding in a narrow rectangular channel with high wall temperature

Design and Evaluation of Mitigation Measures for Tsinghua High Flux Reactor Loss-of-Coolant Accidents

Research on the Key Design of Emergency Core Cooling Scheme for Tsinghua High Flux Reactor

The Conceptual Design of Emergency Core Cooling Scheme for Tsinghua High Flux Reactor

Thermohydraulic Transient Studies of the Chinese 200mwe HTR-PM for Loss of Forced Cooling Accidents

Analysis of Transient Characteristics and Design Improvement of the Passive Residual Heat Removal System of NHR-200-II

Experimental study on flow break by nuclear heating reactor LOCA under shutting down incompletely

Preliminary Investigation of THFR Passive Residual Heat Removal System

Experimental Investigation of Early Initiation of Primary Cooldown by Secondary-Side Depressurization in A Pwr Inadequate Core-Cooling Accident

Numerical investigation on the core thermal hydraulic behavior of pool-type sodium-cooled fast reactor (SFR)

Instability under flow break by nuclear heating reactor LOCA

CFD simulation on the transient process of coolant mixing phenomenon in reactor pressure vessel

A Numerical Investigation of SBLOCA Scenario in Nuclear Heating Reactor