Abstract:The advanced pressurized water reactor with a tight hexagonal lattice core design has its potential to improve uranium utilization. With a smaller pitch-to-diameter ratio (p/d) ranging from 1.05 to 1.20, a major problem of a tight lattice core is the emergency core cooling in a loss-of-coolant accident. The NEPTUN-LWHCR and FLORESTAN reflooding experiments preformed at PSI (Paul Scherrer Institute) and KfK ( Kernforschungszentrum Karlsruhe) during the verification period 1985-1990 showed that a LWHCR (light water high conversion reactors) had higher peak cladding temperatures and smaller quench rates than that of a conventional LWR (Rouge and Dreier, 1992; Erbacher and Wiehr, 1988). Furthermore, the existing system codes like RELAP5, CATHARE, TRAC may not be able to simulate the reflooding phase of a LWHCR. In this paper, the characteristics of the reflooding phase of tight lattice cores have been investigated. Then improvements to heat transfer models of precursory cooling have been introduced into RELAP5/MOD3.2. In addition, a new model has been developed to predict the heat release in the vicinity of the quench front. These modifications are assessed using selected tests of NEPTUN-LWHCR and FLORESTAN experiments. Comparisons between the calculated results and measured data indicate that the modified code can predict the peak cladding temperatures and quench temperatures relatively well. While for droplet entrainment prediction, there is still large room for improvement. Further validation is needed for the models proposed in this paper especially for a tight lattice core with a p/d ratio less than 1.10, and more efforts are required to study the droplet distribution and droplet size downstream of the quench front for higher reflooding rate tests (larger than 4.5 cm/s). (C) 2012 Elsevier B.V. All rights reserved.

Research on the Key Design of Emergency Core Cooling Scheme for Tsinghua High Flux Reactor

The Conceptual Design of Emergency Core Cooling Scheme for Tsinghua High Flux Reactor

Design and Evaluation of Mitigation Measures for Tsinghua High Flux Reactor Loss-of-Coolant Accidents

Early Mitigation Measures for High Flux Reactor Loss-of-Coolant Accidents

Transient Analysis of Active Cooling Procedure of HTR Reactor Core

Preliminary Investigation of THFR Passive Residual Heat Removal System

CFD simulation on the transient process of coolant mixing phenomenon in reactor pressure vessel

Reflooding characteristics investigation and predicted models improvement for the pressurized water reactor with the tight lattice core design

Transient Characteristics of Typical Design Basis Accidents in Integrated Small Reactor NHR200-II Using RELAP5 Model

Research on thermal hydraulic characteristics of reflooding process based on core multi-channel model in system analysis code

Conceptual design and safety characteristics of a new multi-mission high flux research reactor

Progress in Thermohydraulic Analysis of Accident Scenarios of A Water-Cooled Fusion Demo Reactor

Numerical study on the thermal hydraulic characteristics of ERVC system

The Design and CFD Simulation of a New Spent Fuel Pool Passive Cooling System

A SIMULATION OF SMALL BREAK LOSS OF COOLANT ACCIDENT IN NUCLEAR HEATING REACTOR BASED ON RELAP5

Development of 3-D CFD Methodology to Investigate the Transient Thermal-Hydraulic Characteristics of Coolant in a Spent Fuel Pool

The design and simulation of a new spent fuel pool passive cooling system

Study on the Core Cooling Scheme after Accident Shutdown of the Pebble-Bed Modular High Temperature Gas-Cooled Reactor

Conceptual design and analysis of a combined passive cooling system for both reactor and spent fuel of the pool-vessel reactor system

of Smart Grid and Clean Energy Simulation analysis of a passive containment cooling system based on the RELAP 5 program

Prediction of Flow and Temperature Distributions in a High Flux Research Reactor Using the Porous Media Approach