Abstract:An experimental simulation study on the transition from pressurized to boiling operation of a low-temperature, natural circulation nuclear heating reactor (5 MW) developed by INET of Tsinghua University is presented. The experiment was performed on the test loop (HRTL-5), which simulates the geometry and system design of the 5 MW reactor. The manifestation of different kinds of two-phase flow instabilities, namely geysering, flashing instability and low-steam quality density wave instability on the transition from pressurized to boiling operation is described. The mechanism of flashing instability, which has never been studied well on this field, is especially interpreted. It is suggested that the start-up process, from initial condition to boiling operation condition, should consist of three steps: (1) increasing of initial pressure by means of a noncondensable gas (N2), which is a very effective method to eliminate geysering and flashing instability at lower pressure. (2) start-up of the reactor at this pressurized condition with a constant heat flux under the limited value of 9 = 0.15 MW ?m-2, which controls the exit temperature of the heated section below the one of net vapor generation, the low steam quality density wave oscillation can be avoided. (3) transition to a lower pressure, boiling operation. The method of transition with low-heat flux and low-inlet subcooling is proposed: at pressurized operation condition, by reducing the heat flux to its lowest level, releasing the noncondensable gas and increasing the heat flux gradually (dq/dt3 kW ?m- 2 ?min-1l) , during which the low-steam quality density wave oscillation can be be prevented from occurring, then the boiling operation condition can be achieved through adjusting the heat flux and inlet subcooling to their designed value. A stable transition from pressurized to boiling operation of the 5 MW reactor is achieved by careful selection of the thermohydraulic parameters.

Experimental study on flow break by nuclear heating reactor LOCA under shutting down incompletely

Instability under flow break by nuclear heating reactor LOCA

Experimental Study of a Stoppage Natural Circulation During a Nuclear Heating Reactor LOCA

Experimental simulation on LOCA of a nuclear heating reactor

Simulation experiment study on LOCA at upper plenum of nuclear heating reactor

Experimental Study of the Transient Characteristics of A Natural Circulation Loop under Sbloca

Pressure Reducing and Loss of Water under SBLOCA at Upper Plenum of Nuclear Heating Reactors

A Numerical Investigation of SBLOCA Scenario in Nuclear Heating Reactor

Comprehensive Safety Analysis Code System for Nuclear Fusion Reactors III: Ex-Vessel LOCA Analyses Considering Passive Safety

Experimental Investigation of Early Initiation of Primary Cooldown by Secondary-Side Depressurization in A Pwr Inadequate Core-Cooling Accident

Experiment investigation of a secondary PRHR cooling effect on an integral facility after a LOCA accident

Analysis on Flow Characteristic of Nuclear Heating Reactor

Numerical Investigation on Flow Excursion Boundary of A Full Power Natural Circulation Reactor

EXPERIMENTAL STUDY ON LOW PRESSURE FLOW INSTABILITY

Description of typical flow instabilities in the natural circulation system

A SIMULATION OF SMALL BREAK LOSS OF COOLANT ACCIDENT IN NUCLEAR HEATING REACTOR BASED ON RELAP5

The Numerical Simulation Research of Gas–Liquid Two-Phase Flow in Small-Break Loss-of-Coolant Accidents

Flow excursion phenomenon in natural circulation at nuclear heating reactor conditions

Research on Compliance Between Large Break LOCA of HPR1000 and New LOCA Acceptance Criterion 10Cfr50.46c

Experimental Investigation on Flow Behavior During Start-up of a Heating Reactor

Experimental simulation on transit process of the 5MW nuclear reactor