Abstract:To improve the performance of the cell in terms of current density, power density and byproduct water removal from the cathode, three new cathode flow fields are designed, fabricated and tested. Design-1 is a conventional serpentine with a channel width and rib width of 0.8mm . Design-2 is a-four outlet, and one inlet-four zone serpentine with a channel width and rib width of 0.8mm . Design-3 is a four outlet-one inlet four zone serpentine with a gradually reducing channel width from 1.5mm at the inlet to 0.8mm at the four outlets. Design-4 is a four outlet-one inlet four zone zigzag serpentine with a gradually reducing channel width from 1.5mm at the inlet in the middle to 0.8mm at the four outlets. The open angle of 0.16° is used in design-3 and design-4. All the designs cover a 50mm×50mm area with open ratios in the range 48.9% - 50.0% . To assess the cell's performance, an experimental study is conducted to determine the effect of the new cathode flow field design along with methanol flow rates and methanol concentrations. Electrochemical characterization methods are used to measure the power density of the new fabricated transparent DMFC. Results indicate that the highest recorded limiting current density and peak power density by the experiment are 460mA/cm2 and 50mW/cm2 respectively. The reference design using a conventional serpentine flow field attains a current density of 257mA/cm2 and power density of 24mW/cm2 . Comparing new cathode designs with the reference one, the enhancement percentage in terms of the maximum peak power density by design-2, -3 and -4 are 44% , 107% and 22% , respectively. The lower anode flowrates outperforms the higher flowrates. The byproduct water at the cathode was better removed by the new cathode designs compared to the reference design. This research provides leeway for researchers to enhance the performance of DMFCs via new cathode flow fields.

Influence of liquid electrolyte and liquid flowing electrolyte on the performance of an air breathing direct methanol fuel cell (ABDMFC)

Influence of intermediate liquid electrolyte layer on the performance of passive direct methanol fuel cell

Optimization of Membrane Electrode Assembly in Air-Breathing Direct Methanol Fuel Cell

Experimental investigations on the effect of current collector open ratio on the performance of a passive direct methanol fuel cell with liquid electrolyte layer

A Study of the Direct Dimethyl Ether Fuel Cell Using Alkaline Anolyte

Effect of flow characteristics and temperature on performance and efficiency of a direct methanol fuel cell stack

A breakthrough in the performance and fuel utilization of methanol microfluidic fuel cell via viscous co-flow electrolyte

Enhancing the performance of direct methanol fuel cells using new cathode flow field designs: An experimental investigation

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

The Effect of Methanol Concentration on the Performance of A Passive Dmfc

Novel Anode Electrode Structure with a Fuel Management Layer for High-Concentration Passive Direct Methanol Fuel Cells

Influence of Current Collector Design and Combination on the Performance of Passive Direct Methanol Fuel Cells

The optimization performance of cross‐linked sodium alginate polymer electrolyte bio‐membranes in passive direct methanol/ethanol fuel cells

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

A feasibility analysis for alkaline membrane direct methanol fuel cell: thermodynamic disadvantages versus kinetic advantages

Numerical simulation on mass transport in a passive vapor-fed direct methanol fuel cell operating with neat methanol

A High-Performance Direct Methanol Fuel Cell Technology Enabled by Mediating High-Concentration Methanol Through a Graphene Aerogel

Critical materials and technology in direct methanol fuel cells

The Effect of a Reduction in the Catalyst Loading on a Mini Passive Direct Methanol Fuel Cell

A Shared Anode Flow Field for Direct Methanol Fuel Cell with Enhanced Performance and Decreased Volume

A Neat Methanol Fed Passive DMFC with a New Anode Structure