Abstract:To improve the performance of the cell in terms of current density, power density and byproduct water removal from the cathode, three new cathode flow fields are designed, fabricated and tested. Design-1 is a conventional serpentine with a channel width and rib width of 0.8mm . Design-2 is a-four outlet, and one inlet-four zone serpentine with a channel width and rib width of 0.8mm . Design-3 is a four outlet-one inlet four zone serpentine with a gradually reducing channel width from 1.5mm at the inlet to 0.8mm at the four outlets. Design-4 is a four outlet-one inlet four zone zigzag serpentine with a gradually reducing channel width from 1.5mm at the inlet in the middle to 0.8mm at the four outlets. The open angle of 0.16° is used in design-3 and design-4. All the designs cover a 50mm×50mm area with open ratios in the range 48.9% - 50.0% . To assess the cell's performance, an experimental study is conducted to determine the effect of the new cathode flow field design along with methanol flow rates and methanol concentrations. Electrochemical characterization methods are used to measure the power density of the new fabricated transparent DMFC. Results indicate that the highest recorded limiting current density and peak power density by the experiment are 460mA/cm2 and 50mW/cm2 respectively. The reference design using a conventional serpentine flow field attains a current density of 257mA/cm2 and power density of 24mW/cm2 . Comparing new cathode designs with the reference one, the enhancement percentage in terms of the maximum peak power density by design-2, -3 and -4 are 44% , 107% and 22% , respectively. The lower anode flowrates outperforms the higher flowrates. The byproduct water at the cathode was better removed by the new cathode designs compared to the reference design. This research provides leeway for researchers to enhance the performance of DMFCs via new cathode flow fields.

A Shared Anode Flow Field for Direct Methanol Fuel Cell with Enhanced Performance and Decreased Volume

Anode Flow Field Structures of Micro Direct Methanol Fuel Cell

A microfluidic-structured flow field for passive DMFCs operating with highly concentrated fuels

A Tapered Serpentine Flow Field for the Anode of Micro Direct Methanol Fuel Cells

Novel Anode Electrode Structure with a Fuel Management Layer for High-Concentration Passive Direct Methanol Fuel Cells

Design, Fabrication and Testing of an Air-Breathing Micro Direct Methanol Fuel Cell with Compound Anode Flow Field

Effect of anode flow field on silicon-based µDMFC

Effects of anode flow field design on the performance of micro direct methanol fuel cell

A Neat Methanol Fed Passive DMFC with a New Anode Structure

Influence of Current Collector Design and Combination on the Performance of Passive Direct Methanol Fuel Cells

Investigation Of Mass Transport And Cell Performance On Mu Dmfc With Different Anode Flow Fields

Airfoil Flow Field for Proton Exchange Membrane Fuel Cells Enhancing Mass Transfer with Low Pressure Drop

Design and Simulation of Air-Breathing Micro Direct Methanol Fuel Cells with Different Anode Flow Fields.

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

Operational and Structural Aspects of a Vapor-Feed Semi-Passive Direct Methanol Fuel Cell Supplied with Concentrated Methanol

Passive Vapor-Feed Direct Methanol Fuel Cell Using Sintered Porous Metals to Realize High-Concentration Operation

Passive direct methanol fuel cell using woven carbon fiber fabric as mass transfer control medium

Development of a 4-cell air-breathing micro direct methanol fuel cell stack

Enhancing the performance of direct methanol fuel cells using new cathode flow field designs: An experimental investigation

Addition of Non-Reacting Gases to the Anode Flow Field of DMFCs Leading to Improved Performance

A Water Collecting and Recycling Structure for Silicon-Based Micro Direct Methanol Fuel Cells