Abstract:We present the detailed dc and radio-frequency characteristics of an $\hbox{Al}_{0.3}\hbox{Ga}_{0.7}\hbox{N/GaN/In}_{0.1}\hbox{Ga}_{0.9}\hbox{N/GaN}$ double-heterojunction HEMT (DH-HEMT) structure. This structure incorporates a thin (3 nm) $\hbox{In}_{0.1}\hbox{Ga}_{0.9}\hbox{N}$ notch layer inserted at a location that is 6-nm away from the AlGaN/GaN heterointerface. The $\hbox{In}_{0.1}\hbox{Ga}_{0.9}\hbox{N}$ layer provides a unique piezoelectric polarization field which results in a higher potential barrier at the backside of the two-dimensional electron gas channel, effectively improving the carrier confinement and then reducing the buffer leakage. Both depletion-mode (D-mode) and enhancement-mode (E-mode) devices were fabricated on this new structure. Compared with the baseline AlGaN/GaN HEMTs, the DH-HEMT shows lower drain leakage current. The gate leakage current is also found to be reduced, owing to an improved surface morphology in InGaN-incorporated epitaxial structures. DC and small- and large-signal microwave characteristics, together with the linearity performances, have been investigated. The channel transit delay time analysis also revealed that there was a minor channel in the InGaN layer in which the electrons exhibited a mobility slightly lower than the GaN channel. The E-mode DH-HEMTs were also fabricated using our recently developed $\hbox{CF}_{4}$-based plasma treatment technique. The large-signal operation of the E-mode GaN-based HEMTs was reported for the first time. At 2 GHz, a $\hbox{1} \times \hbox{100}\ \mu\hbox{m}$ E-mode device demonstrated a maximum output power of 3.12 W/mm and a power-added efficiency of 49% with single-polarity biases (a gate bias of $+$0.5 V and a drain bias of 35 V). An output third-order interception point of 34.7 dBm was obtained in the E-mode HEMTs.

Low-Leakage High-Breakdown Laterally Integrated HEMT-LED via n-GaN Electrode

Graphene/p-AlGaN/p-GaN Electron Tunnelling Light Emitting Diodes with High External Quantum Efficiency

Efficiency Improved by Monolithic Integration of HEMT with Vertical-Structure LEDs and Mg Doping on Dry Etched GaN

HEMT Controlled Ultraviolet Light Emitters Enabled by P-GaN Selective Epitaxial Growth

Optoelectronic Devices on AlGaN/GaN HEMT Platform (phys. Status Solidi A 5∕2016)

Low contact resistance and high breakdown voltage of AlGaN/GaN HEMT grown on silicon using both AlN/GaN superlattice and Al0.07Ga0.93N back barrier layer

Current collapse suppression in AlGaInN/GaN HEMTs with thin unintentionally doped GaN channel and AlN back barrier grown on single-crystal AlN substrate

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Direct Epitaxial Approach to Achieve a Monolithic On-Chip Integration of a HEMT and a Single Micro-LED with a High-Modulation Bandwidth

Optoelectronic Devices on AlGaN/GaN HEMT Platform

GaN Based HEMT Materials and Devices Fabricated on SiC Substrate

High-Performance Normally-Off Operation p-GaN Gate HEMT on Free-Standing GaN Substrate

A Novel Normally-off Laterally Coupled p-GaN Gate HEMT

An AlGaN-GaN HEMT with p-GaN Extended Gate for Improvements on Current Dispersion and Breakdown Characteristics

DC and RF Characteristics of AlGaN/GaN/InGaN/GaN Double-Heterojunction HEMTs

Enhanced Performance of GaN Based Light-Emitting Diodes with a Low Temperature P-Gan Hole Injection Layer

Simulation Design of a High-Breakdown-voltage P-Gan-gate GaN HEMT with a Hybrid AlGaN Buffer Layer for Power Electronics Applications

Over 1200 V Normally-OFF P-Nio Gated AlGaN/GaN HEMTs on Si with a Small Threshold Voltage Shift

An AlGaN/GaN HEMT with a reduced surface electric field and an improved breakdown voltage

Breakdown Voltage Enhancement and Specific On-Resistance Reduction in Depletion-Mode GaN HEMTs by Co-Modulating Electric Field

Monolithic integration of GaN-based green micro-LED and quasi-vertical MOSFET utilizing a hybrid tunnel junction