Abstract:Bifacial solar modules are increasingly preferred over monofacial modules to maximize the solar power output within a limited space. Owing to their high efficiency and compatibility with existing production lines, bifacial p-type passivated emitter and rear contact (p-PERC) solar modules have dominated the market since their commercialization. This study analyzes the influence of Al 2 O 3 , a passivation layer of p-PERC solar cells, on the PID and its underlying mechanism. Experiments were conducted on bifacial p-PERC module samples to analyze their electrical properties. Additionally, cell-like samples were fabricated to measure characteristics, for example, carrier lifetime, that are difficult to assess in full modules. To accelerate module degradation, experiments were conducted at 85 °C and 85 % humidity, while a voltage of −1000 V was applied to investigate the PID phenomenon. The results reveal degradation at the rear of the module caused by polarization effects, which were confirmed through changes in solar cell parameters and recombination current. The proposed mechanism indicates that the degradation in bifacial p-PERC solar modules is caused by the field-effect deterioration of the Al2O3 layer caused by alkali ions diffusing from the glass. This is observed through changes in the carrier concentration within Si and the detection of alkali ions within Al 2 O 3 . Our analysis considers both module and cell structure samples to delineate the influence of Al 2 O 3 on the PID, which has not been previously reported. This study enhances the understanding of the polarization effect in bifacial p-PERC solar cells, thus contributing to the advancement of solar cell passivation strategies.

Suppression of potential-induced degradation in monofacial PERC solar cells with gradient-designed capping layer

Effective Way to Reduce Rear-Side Potential-Induced Degradation of Bifacial PERC Solar Cells

Reduction of Potential-Induced-Degradation of p-Type PERC Solar Cell Modules by an Ion-Diffusion Barrier Layer Underneath the Front Glass

Potential-induced Degradation: Recombination Behavior, Temperature Coefficients and Mismatch Losses in Crystalline Silicon Photovoltaic Power Plant

Potential-Induced Performance Degradation (PID) Applied on a Perovskite Solar Cell: Exploring Its Effect on Cell Performance Through Numerical Simulation

Light management of PERC solar cell with the front and back dielectric multilayers

Prevention of potential‐induced degradation using a moisture barrier in crystalline silicon photovoltaic modules

Suppressing surface and interface recombination to afford efficient and stable inverted perovskite solar cells

Influence of Al2O3/SiNx Rear-Side Stacked Passivation on the Performance of Polycrystalline PERC Solar Cells

Characterization of rear-side potential-induced degradation in bifacial p-PERC solar modules

Passivated Emitter and Rear Cell Silicon Solar Cells with a Front Polysilicon Passivating Contacted Selective Emitter

Potential-induced degradation of encapsulant-less p-type crystalline Si photovoltaic modules

Supercharging cell-level potential-induced degradation (PID) testing using a salt-enriched hybrid polymer layer

Ga-doped Czochralski silicon with rear p-type polysilicon passivating contact for high-efficiency p-type solar cells

Rear Interface Engineering to Suppress Migration of Iodide Ions for Efficient Perovskite Solar Cells with Minimized Hysteresis

Investigation of Potential‐Induced Degradation and Recovery in Perovskite Minimodules

Effect of Potential Induced Degradation on Crystalline Silicon Solar Modules in Photovoltaic Power Plant

Tuning Back Side Passivation for Enhancing the Performance of PERC Solar Cells

Improved Performance and Stability of Perovskite Solar Modules by Regulating Interfacial Ion Diffusion with Nonionic Cross‐Linked 1D Lead‐Iodide

Highly efficient and stable perovskite solar cells enabled by low-dimensional perovskitoids

Gaining Insight Into The Effect Of Organic Interface Layer On Suppressing Ion Migration Induced Interfacial Degradation In Perovskite Solar Cells