Abstract:Low energy production of Nb powders via computer-aided control (CAC) of two-electrode electrolysis of porous Nb2O5 pellets (ca. 1.0 g) has been successfully demonstrated in molten CaCl2 at 1123 K. It was observed that potentiostatic electrolysis of the oxide in a three-electrode cell led to a cell voltage, i.e. the potential difference between the working (cathode) and counter (anode) electrodes, that decreased to a low and stable value within 1-2 h of the potential application until the end of the electrolysis (up to 12 h in this work). The cell voltage varied closely according to the current change. The stabilised cell voltage was below 2.5 V when the cathode potential was more positive than that for the reduction of Ca2+, leading to much lower energy consumption than that of constant voltage (>3.0 V) two-electrode electrolysis, as previously reported. Using a computer to program the variation of the cell voltage of two-electrode electrolysis according to that observed in the potentiostatic three-electrode electrolysis (0.05 V vs. Ca/Ca2+), a Nb powder with ca. 3900 ppm oxygen was produced in 12 h, with the energy consumption being 37.4% less than that of constant voltage two-electrode electrolysis at 3.0 V. Transmission electron microscopy revealed thin oxide layers (4-6 nm) on individual nodular particles (1-5 microm) of the obtained Nb powder. The oxide layer was likely formed in post-electrolysis processing operations, including washing in water, and contributed largely to the oxygen content in the obtained Nb powder.

Chemical Vapor Synthesis of Ultrafine Niobium Powder Via Sodiothermic Reduction of Chloride

Production of niobium powder by direct electrochemical reduction of solid Nb2O5 in a eutectic CaCl2-NaCl melt

Controlled Synthesis of Niobium and Rare Earth Mixed Oxides for Catalytic Combustion of Chlorinated Vocs in the Synthesis Process of Polyether Polyol and Polyurethane

The fabrication of niobium powder by sodiothermic reduction process

Molten Salt Synthesis of ZnNb{sub 2}o{sub 6} Powder

Synthesis and Characterization of Nanocrystalline Niobium Nitride Powders

Synthesis of Nanosized NbN Powder with Cubic Structure by Ammonolysis Method

Low-temperature Synthesis of Nanocrystalline Niobium Nitride Via a Benzene-Thermal Route

LOW-TEMPERATURE PREPARATION OF NANO-CRYSTALLINE LITHIUM NIOBATE POWDERS BY THE POLYMERIC PRECURSOR METHOD

Preparation of Niobium Powders by Sodiothermic Reduction of K 2 NbF 7

Computer-aided control of electrolysis of solid Nb2O5 in molten CaCl2

Low Temperature Synthesis of ZnNb2O6 Fine Powders by Wet-Chemical Processes

Chemical synthesis of stoichiometric lithium niobate powders

Production Of Intermetallic Compound Powders Through Hydrogen And Sodium Reduction Of Chlorides

Synthesis and characterization of superconducting nanocrystalline niobium nitride.

Production Of Nbal3 Powders Through Sodium Reduction Of Oxides In Molten Salts

Synthesis of Stoichiometric LiNbO3 Nanopowder Through a Wet Chemical Method.

Synthesis of niobium pentoxide from bis(cyclopentadienyl) niobium(IV) dichloride using the spin coating process

Preparation of Nb3Al Powder by Chemical Reaction in Molten Salts

An Efficient Approach for Direct Synthesis of K0.5na0.5nbo3 Powders

Direct synthesis of Nb–Al intermetallic nanoparticles by sodiothermic homogeneous reduction in molten salts