Abstract:Niobium oxides are promising materials for applications within various research fields, especially as electrocatalysts for various chemical reactions. The tuning of the synthetic parameters can achieve a successful compromise between morphology and structure, aiming to obtain certain properties. Hence, this study aimed to investigate the influence of hydrothermal synthesis parameters on the morphology and structure of niobium oxide growth on a niobium metallic plate. The effect of annealing on the material performance was also evaluated. Afterward, the most crystalline sample was tested for the electrochemical determination of dissolved oxygen, a fundamental reaction in corrosion, biomedicine, and environmental monitoring. This is the first work using this material configuration as an electrochemical sensor. The hydrothermal synthesis produced nanorods formed by poorly crystalline, acidic, hydrated Nb2O5. Increasing the mineralizer concentration could increase the crystallinity and the nanorod growth rate, but it could also promote a lack of structural and morphological uniformity throughout the surface. Heat treatment allowed the increase in crystallinity and favored orthorhombic Nb2O5. Raman spectroscopy revealed that, at the first moment, acidic, hydrated niobium oxide structures were formed as precursors of crystalline niobium oxide that would be developed with longer reaction times and a higher mineralizer concentration. The obtained niobium oxide showed electrocatalytic activity toward the oxygen reduction reaction, with comparable performance between the samples with and without heat treatment. At all analyzed pH values, the amperometric response was linearly correlated with the dissolved oxygen concentration. pH influenced the sensitivity of the material; a maximum sensitivity of 0.0417 mA/cm2·mg/L O2 was achieved at pH = 6. The participation of the acidic functionalities of the surface in the ORR reaction was confirmed by Raman spectroscopy.

Low-temperature synthesis of niobium oxide nanoparticles from peroxo niobic acid sol.

Hydrothermal synthesis of NaNbO3 with low NaOH concentration

LOW-TEMPERATURE PREPARATION OF NANO-CRYSTALLINE LITHIUM NIOBATE POWDERS BY THE POLYMERIC PRECURSOR METHOD

Antisolvent Precipitation for the Synthesis of Monodisperse Mesoporous Niobium Oxide Spheres as Highly Effective Solid Acid Catalysts

Low-temperature Synthesis of Nanocrystalline Niobium Nitride Via a Benzene-Thermal Route

Low-temperature combustion synthesis of K0.5Na 0.5NbO3 powders

Synthesis of Nanosized NbN Powder with Cubic Structure by Ammonolysis Method

Synthesis and Characterization of Nanocrystalline Niobium Nitride Powders

Synthesis of niobium(iv) carbide nanoparticles via an alkali-molten-method at a spatially-limited surface of mesoporous carbon

Electrochemical Synthesis of Crystalline Niobium Oxide

Synthesis of Single-Crystal Niobium Pentoxide Nanobelts

Formation Mechanism of NaNbO3 Powders During Hydrothermal Synthesis

Synthesis and Properties of Niobia Films Derived from Niobium Pentaethoxide

Synthesis of Stoichiometric LiNbO3 Nanopowder Through a Wet Chemical Method.

Study of the structure of niobium oxide by X-ray absorption fine structure and surface science techniques

Synthesis of niobium pentoxide from bis(cyclopentadienyl) niobium(IV) dichloride using the spin coating process

Facile Synthesis and Unique Photocatalytic Property of Niobium Pentoxide Hollow Spheres and the High Optoelectronic Performance of Their Nanofilm.

Low‐Temperature Synthesis of Nanocrystalline Niobium Nitride Via a Benzene‐Thermal Route.

Fabrication and Characterization of Three-Dimensionally Ordered Macroporous Niobium Oxide

Niobium Oxide Nanorods Obtained by Hydrothermal Synthesis—Structure, Morphology, and Electrochemical Detection of Oxygen Via Oxygen Reduction Reaction

Preparation of ultrafine powders of Nb2O3 by hydrothermal H2O2 oxidation starting from metallic Nb