Abstract:Nickel aluminum bronze (NAB) alloys quenched after rolling to different reduction ratios were used to investigate the microstructure evolution during the heavy warm rolling (HWR) process. The results demonstrate that the average grain size continuously declines as rolling progresses while the dislocation density steadily increases. As a result of Widmanstatten and eutectoid transformation, the β phases are almost entirely transformed into α phases. Simultaneously, different types of k phases also rapidly precipitate from the matrix. After HWR, the microstructure comprises coarse-grained Widmanstatten α phases, ultrafine-grained eutectoid structures, and many types of k phases dispersedly distributed on the matrix. There is no noticeable texture due to the formation of numerous equiaxed α grains generated by eutectoid transformation. As the reduction ratio increases, the increasing dislocation lines gradually become entangled, eventually forming many dislocation cells. The precise statistics of the precipitates' size, position, and area fraction manifest that the newly generated k phases during rolling are primarily distributed in the region of eutectoid structures, and their size is typically below 50 nm. The improvement of the mechanical properties is attributed to the increase of dislocation density and nano precipitates as well as the continuous microstructure refinement. Based on the accurate characterization of microstructures, the phase transformation kinetics during rolling influenced by combined thermo-mechanical effects are holistically described.

Evolution of microstructure and mechanical properties influenced by nanosized precipitates during rolling deformation

Characteristics of microstructural and mechanical evolution in 6111Al alloy containing Al3(Er,Zr) nanoprecipitates

The Influence of Warm Rolling Reduction on Microstructure Evolution, Tensile Deformation Mechanism and Mechanical Properties of an Fe-30Mn-4Si-2Al TRIP/TWIP Steel

Recrystallization Behavior and Mechanical Properties of Az31b Alloy During the Hot-Rolling Process

Texture, Microstructure and Mechanical Properties of 6111 Aluminum Alloy Subject to Rolling Deformation

Effects Of Rolling Process On Microstructure And Mechanical Property Of 7050 Aluminum Alloy

Microstructure evolution, mechanical response, and corrosion resistance for a 2195 Al-Li alloy under different rolling reductions during cryorolling

Effect of Rolling Reduction on Microstructures and Mechanical Properties of Sc-Containing Al-3.2Cu-1.5Li Alloy

The Influence of Annealing on the Microstructural and Textural Evolution of Cold-Rolled Er Metal

Effect of rolling deformation on microstructure and mechanical properties of Mg–Y–Nd–Al alloy

Microstructure evolution behavior and mechanical mechanisms in a near α-Zr alloy by cold rolling

Mechanical property enhancement and microstructure evolution of an Al-Cu-Li alloy via rolling at different temperatures

Evolution of Microstructure and Texture During Recovery and Recrystallization in Heavily Rolled Aluminum

Microstructure evolution during the heavy warm rolling of a nickel aluminum bronze

Microstructure evolution and recrystallization of Ti6246 alloy in hot‐rolling and annealing processes

Microstructure and Mechanical Properties Evolution of the Al, C-Containing CoCrFeNiMn-Type High-Entropy Alloy during Cold Rolling

Effect of cold rolling on microstructure and mechanical properties of pure Zr

Deformation mechanism and mechanical properties of a CoCrFeNi high-entropy alloy via room-temperature rolling, cryorolling, and asymmetric cryorolling

Dynamic recrystallization, texture and mechanical properties of high Mg content Al–Mg alloy deformed by high strain rate rolling

Obtaining Heterogeneous Microstructure and Enhanced Mechanical Properties in ECAP-Processed AZ61 Alloys via Single-Pass Rolling with Increased Rolling Reduction

Improving Precipitation in Cryogenic Rolling 6016 Aluminum Alloys during Aging Treatment