Physical Characteristics of Low-Dose Nitrogen Ions-Implanted Copper Oxide Thin Film on n-Si (100) Substrate

DOI: https://doi.org/10.1007/s13369-024-09107-1
IF: 2.807
2024-05-16
Arabian Journal for Science and Engineering
Abstract:Thin film of copper oxide was deposited onto a silicon substrate through DC magnetron sputtering system. Nitrogen ions (N + ) were implanted into the film using Pelletron Accelerator at different doses (5 × 10 12 , 5 × 10 13 and 5 × 10 14 ions/cm 2 ) while maintaining a constant ion energy of 300 keV. The X-ray diffraction study revealed a diffraction peak of CuO (− 111) in all the samples. The crystallite size of CuO decreased at 5 × 10 12 ions/cm 2 and then increased with the dose up to 5 × 10 14 ions/cm 2 . The decrease in crystallite size was attributed to structural disorder in the film caused by ions irradiation, while at relatively higher doses (> 5 × 10 12 ions/cm 2 ), localized thermal effects improved the structural ordering of the material through the annihilation of defects. The surface morphology of the film showed a decrease in its grain size at 5 × 10 12 ions/cm 2 , followed by an increase with a further increase in the ion dose. N + implantation at 5 × 10 12 ions/cm 2 decreased the surface roughness of CuO, while the roughness remained constant at the higher doses. The electrical resistivity of CuO decreased upon N + implantation at 5 × 10 12 ions/cm 2 and then increased with a further increase in the ion dose. The band gap of the CuO exhibited a similar trend to that of its resistivity and crystallite size. These findings show that the N + implantation serves as an effective method for tuning the physical properties of the copper oxide film, for its superior performance in the electronic and optoelectronic devices.
multidisciplinary sciences
What problem does this paper attempt to address?