Abstract:Abstract Taking No.65 pier of Zhongshan-Tanzhou express line as the background, the construction technology of percussive reverse circulation drilling hole forming squeezed branch pile is studied, the construction process of percussive reverse circulation drilling hole forming squeezed branch pile is defined, and through the field trial hole forming test, the points needing attention in field construction are summarized and improved: (1) The top elevation of the steel casing shall not exceed 30cm of the surface elevation, and the hole diameter of the percussion drilling hole shall be slightly larger than the designed hole diameter, so as to avoid the floating of the steel cylinder and the influence of too small hole diameter on the squeezing operation; (2) hole cleaning operation is an important factor for the success or failure of the squeezed branch pile construction, and the sediment thickness has a great influence on the bearing capacity of the pile foundation. After the expansion equipment is squeezed and the reinforcement cage is lowered, the hole cleaning is carried out, and the control points and mud parameters during each hole cleaning are clarified; (3) during the expansion process, the extrusion pressure value and the floating amount of the expansion equipment should be detailed, the geological information should be verified, and the bearing capacity of the pile foundation should be evaluated.

Application of Full-rotation Complete Tube Technology in the Construction of Pile Foundation in Medium-coarse Sand Geology

Construction Techniques for Reinforcement of Foundation of Existing Bridge Pile with Microsteel-Piped Pile

Innovative Design of Pipe Piles Combined Both the Effect of Pile Foundation and Composite Foundation for Soft Soil Treatment

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

3-D Numerical Simulation for Large-Diameter Cast-<i>In Situ</i> Tubular Pile

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

Analysis of cast-in-situ tubular piles in soft foundation improvement at bridge approaches

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Experimental Study of the Bearing Capacity of a Drainage Pipe Pile under Vacuum Consolidation

Embankment Technique of Shell Tubular Pile of Large-Diameter Placing-in-Situ Concrete

The engineering characteristic of precast tubular pile and mixing cement pile composite foundation for deep soft ground

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

On Anti-slide Pile Technology Applied in Soft Soil Foundation Treatment

A new type of PHC pile-sinking technology: Drilling with PHC Pipe Cased Pile and its development directions

Quality Control for Fabricating Large Diameter Bored Piles in Collapsible Sand Layer Areas

New Form of Pipe Foundation on Deep Weak Subgrade

Study on construction technology of percussive reverse circulation drilling hole forming squeezed branch pile

Construction Technology of a Long Spiral Drilling Pipe CFG Pile

Composite Foundation of Deep Mixing Piles for Large Steel Oil Tanks on Soft Ground

Concrete-Filled Steel Tube cap pile application in engineering

Study on Axial Bearing Properties of Cast-in-place Concrete Thin-Wall Tubular Piles