Abstract:Recently tetrapod piled jacket (TPJ) foundations are considered as a promising solution for offshore wind turbines in waters with depths ranging from 20 m to 50 m. This paper presents a numerical study into the monotonic lateral loading behaviour of TPJ foundations in medium sand, in terms of overall load-displacement responses of TPJ foundations and internal force within individual corner piles as well as pile-soil interaction. The results of previous centrifuge model tests are used to provide high-quality verification for the development of a 3D finite element model established by ABAQUS. A series of parametric studies is then carried out to look into more detailed response of TPJ foundations subjected to lateral loads, including the influence of spacing and slenderness ratio of piles, loading height as well as soil friction angle. The numerical results show that there are two various deformation models of TPJ foundations during lateral loading. One is shearing dominated deformation model under smaller loads, while another one is overturning dominated model under larger loads. Moreover, the lateral soil-pile interaction is found to be greatly influenced by enhancing/weakening effects of the axial forces of individual piles. The cause of this phenomenon is primarily due to the change in soil stress induced by pile vertical movement and radial deformation. To quantify this effect on pile-soil interaction of TPJ foundation, an enhancement factor Gamma(s), defined as the ratio of the soil resistance on downwind piles to that on upwind piles, is proposed. Consequently, the relationship between Gamma(s), depth of influence zone z(c )and four parameters are carefully investigated. For simplicity, the Gamma(s) is assumed constant and independent with pile lateral deflection as well as soil depths, based on which the values for Gamma(s) and z(c) are recommended for practical design uses. It is highlighted in the present study that these values should be chosen based on the specific loading conditions to provide much safer and more robust design for TPJ foundations.

3-D Numerical Simulation for Large-Diameter Cast-<i>In Situ</i> Tubular Pile

3-D Numerical Simulation for Large-Diameter Cast-In-Situ Tubular Pile

STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

A NEW CALCULATION METHOD FOR LARGE-DIAMETER-TUBULAR-PILE BEARING CAPACITY

Experimental Analysis of Bearing Capacity of Cast-in-place Tubular Pile

A Numerical Study on the Lateral Loading Behaviour of Offshore Tetrapod Piled Jacket Foundations in Clay

Analysis of Axial Load-Transfer of Large-Diameter Cast-in-situ Tubular Pile

Performance analysis of cast-in-place tubular pile composite ground under embankment load

Analytical Elastoplastic Solutions of Laterally Loaded Long Piles

Finite Element Analysis of Compacting Displacements of Single Jacked Pile

Numerical Investigation on the Lateral Loading Behaviour of Tetrapod Piled Jacket Foundations in Medium Dense Sand

Experimental Study on Bearing Capacity Behavior of Deep Large Diameter Cast-in-place Belled Pile

Study on Axial Bearing Properties of Cast-in-place Concrete Thin-Wall Tubular Piles

RESEARCH ON INFLUENCE OF SOIL CORE ON BEARING CHARACTER OF LARGE-DIAMETER TUBULAR PILE USING CAST-IN-SITU CONCRETE

Theoretical Solution for Long-Term Settlement of a Large Step-Tapered Hollow Pile in Karst Topography

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Numerical analysis on the performance of a cushioned foundation with a mixture of both rigid and flexible piles

A Simplified Nonlinear Calculation Method to Describe the Settlement of Pre-Bored Grouting Planted Nodular Piles

Numerical Simulation and Factor Analysis of Jacked Pile Compacting Effects

3-D Numerical Simulation for Large-Diameter Cast-&lt;i&gt;In Situ&lt;/i&gt; Tubular Pile