Abstract:Displacement piles are driven to support a wide range of structures. However, analysis of the stress and strain fields developed during their installation remains one of the most challenging problems in geotechnical engineering. Advances in design methods, particularly for sand sites, have had to rely on an imperfect analogy between pile and cone penetration test (CPT), rather than modeling pile installation itself. Recent physical model experiments have provided benchmark data sets that describe the stress and deformation patterns developed around displacement piles penetrating sand masses. Following from large-deformation finite-element analyses that captured the stresses measured in the Grenoble 3S-R calibration chamber NE34 sand experiments, this paper presents simulations of the displacements measured in equivalent high-quality experiments conducted at Purdue University with dense, angular #2Q-ROK silica sand. A modified Mohr-Coulomb model with state-dependent parameters was calibrated to match element tests conducted by the authors, and an arbitrary Lagrangian-Eulerian scheme was applied in the simulations. The evolution and distribution of the deformations induced by pile penetration are compared with the experiments. Predictions for the deformation and strain fields applying during and after pile installation are presented, showing broad agreement between the simulations and experiments. The predicted and measured pile capacities are also compared and contrasted. Points of divergence between the simulations and tests are highlighted and their implications for numerical modeling are discussed.

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Stresses Developed Around Displacement Piles Penetration in Sand

Theoretical Breakage Mechanics and Experimental Assessment of Stresses Surrounding Piles Penetrating into Dense Silica Sand

Three-Dimensional DEM Simulation of Plugging Behaviour of Small-Diameter Open-Ended Model Piles Penetrating Into Sand

Sand Grain Crushing and Interface Shearing During Displacement Pile Installation in Sand

Advanced laboratory investigation of axial cyclic loading in silica sands

Performance of laterally loaded H-piles in sand

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Field and Model Investigations into the Influence of Age on Axial Capacity of Displacement Piles in Silica Sands

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Finite Element Analysis of Compacting Displacements of Single Jacked Pile

Material point method simulations of displacement pile and CPT penetration in sand considering the effects of grain breakage

MPM Simulation of the Installation of an Impact-Driven Pile in Dry Sand and Subsequent Axial Bearing Capacity

Bearing capacity and deflection behaviors of large diameter monopile foundations in sand seabed