Abstract:Previous studies on laterally loaded piles in clay have mainly focused on flexible and rigid piles. Little attention has been paid to semi-rigid piles (whose pile–soil stiffness lies somewhere between those of rigid and flexible piles), which may behave as either flexible piles or rigid piles, depending on the change in soil stiffness during cycling. This study aims to understand the cyclic lateral response of a repeatedly loaded semi-rigid pile in soft clay and the failure mechanisms of the soil around the pile, through a series of centrifuge model tests and three-dimensional finite element analyses using an advanced hypoplastic clay model. Numerical parametric studies were also performed to investigate the evolution of soil flow mechanisms with increasing pile rigidity. It is revealed that the semi-rigid pile behaved as if it were a flexible pile (i.e., flexural deformation dominated) during the first few cycles, but tended to behave like a rigid pile (i.e., rotational movement prevailed) during subsequent cycles, which progressively softened the surrounding soil. As a result, the mechanisms of soil flow around the semi-rigid pile exhibited an intermediate behaviour combining the mechanisms of both flexible and rigid piles. Three distinctive mechanisms were identified: a wedge-type mechanism near the surface, a full-flow mechanism (within the transverse sections) near the middle of the pile, and a rotational soil flow mechanism (in the vertical symmetrical plane of the pile) near the lower half of the pile. By ignoring the rotational soil flow mechanism, which has a much lower resistance than the full-flow mechanism, the American Petroleum Institute code (published in 2007) underestimated the cyclic bending moment and the lateral pile displacement by 10% and 69%, respectively. Application of jet grouting around the semi-rigid pile at shallow depth significantly altered the soil flow mechanism (i.e., it was a solely wedge-type mechanism around the grouted zone).

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Advanced laboratory investigation of axial cyclic loading in silica sands

Stress Paths Measured Around A Cyclically Loaded Pile In A Calibration Chamber

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Large Deformation Finite-Element Simulation of Displacement-Pile Installation Experiments in Sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Performance of laterally loaded H-piles in sand

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Lateral Cyclic Pile–soil Interaction Studies on a Rigid Model Monopile

Field and Model Investigations into the Influence of Age on Axial Capacity of Displacement Piles in Silica Sands

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

A Destructive Field Study on the Behavior of Pile under Ten

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings

Experimental Study on Pile-Soil Interaction Response in Saturated Sand under Long-Term Horizontal Cyclic Loading

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

Model tests of single pile vertical cyclic loading in calcareous sand